Most common failures | No# failures |
---|
Brake pipe excessively corroded | 4 |
Headlamp aim out of alignment | 2 |
Parking brake: efficiency below requirements |3.7.B.7| | 2 |
Offside Front position lamp|s| not working |1.1.A.3b| | 2 |
Offside Front Drag link end ball joint has excessive play |2.2.B.1f| | 2 |
Brakes imbalanced across an axle | 2 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Registration plate lamp issues | 1 |
Rear Rear fog lamp not working |1.3.2b| | 1 |
Nearside Rear Shock absorber has a serious fluid leak |2.7.3| | 1 |
Parking brake lever has no reserve travel |3.1.6b| | 1 |
Rear parking brake recording little or no effort | 1 |
Rear brake application uneven | 1 |
Nearside Rear Leaf spring has excessive wear in a shackle pin and/or bush |2.4.B.2| | 1 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 1 |
Offside Front Axle swivel joint has excessive movement between a swivel joint and its housing |2.5.A.1b| | 1 |
Offside Rear fog lamp not working |1.3.2b| | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Centre Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Rear Leaf spring has a deteriorated shackle pin rubber bush resulting in excessive movement |2.4.B.2| | 1 |
Offside Rear Leaf spring has a deteriorated shackle pin rubber bush resulting in excessive movement |2.4.B.2| | 1 |
Nearside Front drive shaft coupling flexible rubber or fabric coupling softened by oil contamination |2.5.C.1e| | 1 |
Offside Front Direction indicator not working |1.4.A.2c| | 1 |
Rear Exhaust has a part missing |7.1.1a| | 1 |
Offside Front wheel bearing has excessive play |2.5.A.3c| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Rear Drag link end ball joint has excessive play |2.2.B.1f| | 1 |
Exhaust emits an excessive level of metered smoke for a non-turbo charged engine |7.4.B.3b| | 1 |
Offside Rear Leaf spring fractured |2.4.B.1a| | 1 |
Nearside Rear Rear fog lamp not working |1.3.2b| | 1 |
Offside Lower Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |