| Most common failures | No# failures |
|---|
| Windscreen wiper does not clear the windscreen effectively | 8 |
| Headlamp aim out of alignment | 7 |
| Offside Rear Rear fog lamp not working (4.5.1 (a) (ii)) | 3 |
| Offside Rear Service brake excessively binding (1.2.1 (f)) | 3 |
| Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i)) | 2 |
| Anti-lock braking system warning lamp indicates an ABS fault | 2 |
| Offside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 2 |
| Brake hose excessively deteriorated | 2 |
| Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c)) | 2 |
| Rear fog lamp not working (4.5.1 (a) (ii)) | 2 |
| Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 2 |
| Windscreen washer not working | 2 |
| Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 2 |
| Offside Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Nearside Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i)) | 1 |
| Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Nearside Front Shock absorbers has a serious fluid leak | 1 |
| Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Offside Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a)) | 1 |
| Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b)) | 1 |
| Brakes imbalanced across an axle | 1 |
| Rear Service brake excessively fluctuating Both (1.2.1 (e)) | 1 |
| Brake load sensing valve linkage defective and function impaired (1.1.17 (a)) | 1 |
| Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Brake pipe excessively corroded | 1 |
| Nearside Front Hydraulic brake calliper inadequately mounted Bolt loose (1.1.16 (c) (i)) | 1 |
| Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b)) | 1 |
| Front Prop shaft joint excessively worn (6.1.7 (c) (i)) | 1 |
| Brake fluid contaminated (1.8 (a)) | 1 |
| Nearside Front Brake hose damaged and likely to fail split casing (1.1.12 (a)) | 1 |
| Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Registration plate lamp issues | 1 |
| Battery insecure and likely to cause a short circuit auxiliary battery (4.13 (a) (ii)) | 1 |
| Nearside Rear Outer Seat belt not functioning as intended (7.1.2 (c)) | 1 |
| Offside Rear Outer Seat belt buckle not functioning as intended (7.1.2 (d)) | 1 |
| Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a)) | 1 |
| Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b)) | 1 |
| Nearside Rear Upper Shock absorbers has an excessively worn bush (5.3.2 (c)) | 1 |
| Nearside Front Brake hose leaking on a hydraulic braking system (1.1.12 (c) (ii)) | 1 |
| Nearside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b)) | 1 |
| Supplementary restraint system warning lamp indicates a fault (7.1.6 (a)) | 1 |
| Nearside Rear Service brake excessively binding (1.2.1 (f)) | 1 |
| Offside Rear Vehicle structure excessively corroded within 30cm of towbar mounting (6.1.6 (i) (i)) | 1 |
| Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Nearside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Rear Seat belt not functioning as intended (7.1.2 (c)) | 1 |
| Nearside Front Lower Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Nearside Rear Seat belt not functioning as intended (7.1.2 (c)) | 1 |
| Offside Front Lower Suspension arm corroded and seriously weakened @ shock absorber mount (5.3.3 (b) (i)) | 1 |
| Offside Front Lower Suspension arm corroded and seriously weakened (5.3.3 (b) (i)) | 1 |
| Offside Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill holed (6.1.1 (c) (i)) | 1 |
| Central Front Axle insecure front diff / rear mounting broken off (5.1.1 (b) (i)) | 1 |
| Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 1 |