Most common failures | No# failures |
---|
Registration plate issues | 3 |
Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h)) | 2 |
Headlamp aim out of alignment | 2 |
Windscreen wiper does not clear the windscreen effectively | 2 |
Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 2 |
Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 2 |
Registration plate lamp issues | 2 |
Rear fog lamp switch missing (4.5.3 (a)) | 2 |
Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c)) | 2 |
Nearside Rear Suspension has inadequate clearance with the chassis |2.4.A.1a| | 1 |
Offside Rear Suspension has inadequate clearance with the chassis |2.4.A.1a| | 1 |
Electronic stability system warning lamp indicates a fault |3.4.1c| | 1 |
Nearside Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Rear brake binding | 1 |
Offside Rear Rear reflector missing |4.8.2 |a| |ii|| | 1 |
Anti-lock braking system warning lamp does not illuminate |1.6 |a|| | 1 |
Brake performance not tested |1.2.1 |g|| | 1 |
Hazard warning switch inoperative |4.4.2 |a| |ii|| | 1 |
Nearside Rear Brake disc significantly and obviously worn |1.1.14 |a| |i|| | 1 |
Front Service brake excessively binding Both sides |1.2.1 |f|| | 1 |
Rear Service brake excessively binding Both sides |1.2.1 |f|| | 1 |
Offside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
Nearside Rear Lower Anti-roll bar ball joint likely to become detached (5.3.4 (a) (ii)) | 1 |
Nearside Rear Lower Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
Nearside Front Lower Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
Nearside Headlamp not working on main beam |1.7.5a| | 1 |
Electronic braking system warning device indicates a fault (1.7 (b)) | 1 |
Rear fog lamp missing |1.3.2a| | 1 |
Rear fog lamp switch missing |1.3.1a| | 1 |
Nearside Front Front position lamp|s| incorrect colour |1.1.A.3e| | 1 |
Offside Front position lamp|s| incorrect colour |1.1.A.3e| | 1 |
Rear fog lamp missing (4.5.1 (a) (ii)) | 1 |
Brakes imbalanced across an axle | 1 |
Side repeater missing nearside and offside (4.4.1 (a) (ii)) | 1 |
Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced suspension bump stop (6.1.1 (c) (i)) | 1 |
Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced floor above axle (6.1.1 (c) (i)) | 1 |
Offside Rear Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced end sill (6.1.1 (c) (i)) | 1 |
Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Nearside Rear Suspension arm severely distorted |2.4.G.1| | 1 |
Offside Rear Rear fog lamp not working |4.5.1 |a| |ii|| | 1 |
Offside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i)) | 1 |
Offside Front Steering linkage ball joint has excessive play steering arm (2.1.3 (b) (i)) | 1 |
Offside Rear Rear fog lamp missing (4.5.1 (a) (ii)) | 1 |
Exhaust has a major leak of exhaust gases Tailpipe perforated rest of system poor (6.1.2 (a)) | 1 |
Exhaust emissions likely to be affected by an exhaust leak Causing Lambda failure (8.2.1.1 (b)) | 1 |
Front Brake disc significantly and obviously worn Inner faces very poor (1.1.14 (a) (i)) | 1 |
Offside Front Service brake excessively binding (1.2.1 (f)) | 1 |
Electronic stability control warning lamp indicates a fault (7.12 (e)) | 1 |
Offside Side repeater light intensity significantly reduced (4.4.3 (a)) | 1 |