Most common failures | No# failures |
---|
Offside Front front brake binding |3.7.B.1| | 3 |
Brakes imbalanced across an axle | 3 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 3 |
Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Brake pedal has no servo assistance |3.3.B.2| | 2 |
Windscreen wiper does not clear the windscreen effectively | 2 |
Nearside Front Lower Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
Offside Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
Offside Front Macpherson strut corroded and seriously weakened |2.4.G.1| | 1 |
Offside Front brake caliper leaking |3.6.A.1| | 1 |
Offside Front Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Nearside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Offside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Registration plate issues | 1 |
Horn not working |1.6.2a| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 1 |
Exhaust engine idle speed too high |7.3.A.2a| | 1 |
Offside Inner Front Upper Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
Nearside Front Lower Vehicle structure has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Front Lower Vehicle structure is damaged, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
Offside Front Lower Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Inner Rear Upper Vehicle structure has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Steering column top mounting bracket insecure |2.1.2d| | 1 |
Nearside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Steering component mounting prescribed area is excessively corroded |2.2.C.1h| | 1 |
Offside Rear position lamp|s| incorrect colour |1.1.A.3e| | 1 |
Offside Rear Stop lamp emits other than a steady red light |1.2.1e| | 1 |
Vehicle structure is damaged, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Rear wheel cylinder has restricted free movement |3.5.1k| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Headlamp not working on main beam |1.7.5a| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside rear brake grabbing severely |3.7.A.5b| | 1 |
Nearside Rear wheel bearing rough when rotated |2.6.1| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Nearside Front front brake binding |3.7.B.1| | 1 |
Offside Rear Shock absorber detached |2.7.2b| | 1 |