Most common failures | No# failures |
---|
Windscreen wiper does not clear the windscreen effectively | 12 |
Headlamp aim out of alignment | 12 |
Registration plate lamp issues | 7 |
Brake pipe excessively corroded | 7 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 6 |
Registration plate issues | 6 |
Rear parking brake recording little or no effort | 5 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 5 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 5 |
Horn not working |1.6.2a| | 4 |
Parking brake: efficiency below requirements |3.7.B.7| | 4 |
Brakes imbalanced across an axle | 4 |
Offside Front position lamp|s| not working |1.1.A.3b| | 3 |
Brake hose excessively deteriorated | 3 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 3 |
Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
Offside Stop lamp not working |1.2.1b| | 2 |
Front position lamp|s| not working |1.1.A.3b| | 2 |
Nearside Stop lamp not working |1.2.1b| | 2 |
Offside Front wheel bearing rough when rotated |2.5.A.2| | 2 |
Nearside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 2 |
Offside Front Front position lamp|s| not working |1.1.A.3b| | 2 |
Offside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 2 |
Offside Front Wheel nut|s| missing |4.2.A.1e| | 2 |
Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Centre Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Offside Rear Shock absorber has negligible damping effect |2.7.5| | 2 |
Nearside Rear Coil spring not correctly located |2.4.C.2| | 2 |
Front passenger door cannot be opened from inside the vehicle |6.2.B.1b| | 2 |
Nearside Windscreen wiper blade deteriorated |8.2.2| | 1 |
Nearside Front Headlamp excessively damaged so that the light output is severely reduced |1.7.5a| | 1 |
Offside Rear Service brake indicates brake bind |3.7.D.2a| | 1 |
Vehicle structure has damage which adversely affects braking or steering |6.1.A.1| | 1 |
Offside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Front Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2| | 1 |
Offside Front Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2| | 1 |
Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
Offside Rear fog lamp not working |1.3.2b| | 1 |
Offside Rear Vehicle structure has excessive corrosion which adversely affects braking or steering inner wing |6.1.A.1| | 1 |
Offside Front Vehicle structure has excessive corrosion which adversely affects braking or steering inner wing |6.1.A.1| | 1 |
Offside Vehicle structure has excessive corrosion which adversely affects braking or steering chassis |6.1.A.1| | 1 |
Nearside Vehicle structure has excessive corrosion which adversely affects braking or steering bulk head |6.1.A.1| | 1 |
Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Offside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Offside Side repeater not working |1.4.A.2c| | 1 |
Rear position lamp|s| not working |1.1.A.3b| | 1 |
Stop lamp not working |1.2.1b| | 1 |
Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings offside and nearside front main chassis members |6.1.B.2| | 1 |
Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings offside and nearside front flooring |6.1.B.2| | 1 |
Nearside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Steering system has excessive free play detected at the steering wheel |steering box fitted| |2.2.A.1a| | 1 |
Nearside Inner Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Nearside Steering pivot point has excessive play idler |2.2.B.1g| | 1 |
Offside Rear Lower Coil spring mounting corroded and seriously weakened |2.4.C.3c| | 1 |
Direction indicator incorrect colour (1.4.A.2f) | 1 |
Parking brake is not capable of being maintained in operation by direct mechanical action only (3.1.2) | 1 |
Steering wheel retaining device missing (2.1.6) | 1 |
Nearside Outer Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Outer Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Braking system leaking |3.6.A.1| | 1 |
Brake master cylinder fluid level below minimum level |3.6.G.1e| | 1 |
Offside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Offside Front Headlamps matched pair are not the same colour |1.7.6| | 1 |
Parking brake is not capable of being maintained in operation by direct mechanical action only |3.1.2| | 1 |
Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Front Stop lamp not working |1.2.1b| | 1 |
Rear brake application uneven | 1 |
Nearside Front Lower Front suspension retaining device ineffective excessive play both mounting bolts on ball joint |2.5.A.4| | 1 |
Offside Rear Stop lamp not working |1.2.1b| | 1 |
Nearside Rear Suspension component mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Offside Rear Suspension component mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Battery insecure |1.9.1| | 1 |
Nearside Front Direction indicators not working |1.4.A.2c| | 1 |
Headlamp not working on dipped beam |1.7.5a| | 1 |
Headlamp not working on main beam |1.7.5a| | 1 |
Front Direction indicator not working |1.4.A.2c| | 1 |
Nearside Front Brake hose leaking |3.6.A.1| | 1 |
Brake pedal creeps down when held under pressure |3.3.B.1a| | 1 |
Front Mechanical brake component securing device missing |3.5.1i| | 1 |
Driver`s door cannot be opened from inside the vehicle |6.2.B.1b| | 1 |
Driver`s door cannot be opened from outside the vehicle |6.2.B.1b| | 1 |
Front passenger door cannot be opened from outside the vehicle |6.2.B.1b| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Front Front suspension retaining device missing |2.5.A.4| | 1 |
Offside Front Coil spring not correctly located |2.4.C.2| | 1 |
Offside Rear Coil spring not correctly located |2.4.C.2| | 1 |
Offside Front Wheel nut|s| loose |4.2.A.1e| | 1 |
Nearside Front Steering locking device missing |2.2.C.1g| | 1 |
Offside Front Headlamp insecure |1.7.3| | 1 |
Nearside Front Headlamp missing |1.7.3| | 1 |
Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
Exhaust system not adequately supported |7.1.1| | 1 |
Rear brake binding | 1 |
Nearside Outer Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Mechanical brake component has restricted free movement | 1 |
Rear Exhaust has a part missing |7.1.1a| | 1 |
Nearside Rear Shock absorber has a serious fluid leak |2.7.3| | 1 |
Nearside Front passenger door cannot be opened from outside the vehicle |6.2.B.1b| | 1 |
Offside Front Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Nearside Inner Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Inner Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Inner Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Nearside Inner Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Front brake caliper has restricted free movement |3.5.1k| | 1 |
Exhaust mounting missing |7.1.1b| | 1 |
Nearside Rear Stop lamp not working |1.2.1b| | 1 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Offside Rear Inner Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings arch |6.1.B.2| | 1 |
Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings outer arch |6.1.B.2| | 1 |
Front front brake binding x2 |3.7.B.1| | 1 |
Offside Rear front brake binding |3.7.B.1| | 1 |
Front front brakes release unevenly |3.7.B.4| | 1 |
Rear front brakes release unevenly |3.7.B.4| | 1 |
Nearside Rear Parking brake inoperative on one side |1.4.1 |a|| | 1 |
Offside Front Headlamp not working on dipped beam |4.1.1 |a| |ii|| | 1 |
Service brake efficiency less than 50% of the required value |1.2.2 |a| |ii|| | 1 |
Parking brake efficiency less than 50% of the required value |1.4.2 |a| |ii|| | 1 |
Brake performance not tested |3.7.A.1| | 1 |
Brake fluid warning lamp illuminated |3.6.G.2| | 1 |
Front front brake binding |3.7.B.1| | 1 |
Offside Rear Seat belt insecurely fixed to the vehicles structure |5.2.1a| | 1 |
Offside Rear Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Front Shock absorber has a serious fluid leak |2.7.3| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded sill |2.4.A.3| | 1 |
Nearside Steering rack gaiter split |2.2.D.2d| | 1 |
Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Nearside Rear Shock absorber has an excessively worn bush |2.7.4| | 1 |
Nearside Side repeater not working |1.4.A.2c| | 1 |
An item not tested |Manual| | 1 |
Offside Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Offside Rear brake disc excessively pitted |3.5.1h| | 1 |
Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Front coil spring incomplete |2.4.C.1a| | 1 |
Offside Headlamp not working on main beam |1.7.5a| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Front brake application uneven | 1 |