Most common failures | No# failures |
---|
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 4 |
Registration plate lamp issues | 3 |
Headlamp aim out of alignment | 3 |
Rear Exhaust system not adequately supported |7.1.1| | 3 |
Brake pipe excessively corroded | 3 |
Windscreen wiper does not clear the windscreen effectively | 3 |
Offside Rear Stop lamp not working |1.2.1b| | 2 |
Nearside Front Front position lamp|s| not working |1.1.A.3b| | 2 |
Offside Front Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Nearside Front Shock absorber has negligible damping effect |2.7.5| | 1 |
Offside Front Shock absorber has negligible damping effect |2.7.5| | 1 |
Nearside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 1 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Rear Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
Offside Rear Rear position lamp|s| not working |1.1.A.3b| | 1 |
Rear Exhaust mounting missing |7.1.1b| | 1 |
Nearside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Front brake application uneven | 1 |
Offside Front Road wheel bead rim badly distorted |4.2.A.1a| | 1 |
Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Front Exhaust system not adequately supported |7.1.1| | 1 |
Rear Fuel cap/sealing device missing |7.2.4a| | 1 |
Offside Rear Road wheel bead rim badly distorted |4.2.A.1a| | 1 |
Horn not working |1.6.2a| | 1 |
Offside Front brake disc excessively pitted |3.5.1h| | 1 |
Nearside Front brake disc excessively pitted |3.5.1h| | 1 |
Nearside Front Windscreen wiper blade deteriorated |8.2.2| | 1 |
Offside Front Windscreen wiper blade deteriorated |8.2.2| | 1 |
Nearside Front Body has a sharp edge caused by corrosion wing |6.1.C.1| | 1 |
Offside Front Body has a sharp edge caused by corrosion wing |6.1.C.1| | 1 |
Nearside Front Front position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Nearside Side repeater missing |1.4.A.2b| | 1 |
Offside Side repeater not working |1.4.A.2c| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Offside Outer Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |