Most common failures | No# failures |
---|
Exhaust emissions hydrocarbon content excessive |7.3.B.1b| | 2 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 2 |
Offside Front position lamp|s| not working |1.1.A.3b| | 2 |
Brake load sensing valve linkage seized |3.6.E.3| | 2 |
Offside Rear fog lamp not working |1.3.2b| | 2 |
Battery insecure |1.9.1| | 1 |
Headlamp aim out of alignment | 1 |
Registration plate lamp issues | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Brake load sensing valve seized |3.6.E.3| | 1 |
Brake pipe excessively corroded | 1 |
Nearside Front Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
Offside Rear Vehicle structure has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |
Offside Side repeater not working |1.4.A.2c| | 1 |
Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Exhaust system not adequately supported |7.1.1| | 1 |
Nearside Front passenger door cannot be opened from outside the vehicle |6.2.B.1b| | 1 |
Nearside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Rear brake binding | 1 |