Most common failures | No# failures |
---|
Brake pipe excessively corroded | 10 |
Headlamp aim out of alignment | 9 |
Windscreen wiper does not clear the windscreen effectively | 9 |
Brake hose excessively deteriorated | 5 |
Service brake: efficiency below requirements |3.7.B.7| | 4 |
Exhaust mounting missing |7.1.1b| | 4 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 3 |
Brakes imbalanced across an axle | 3 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Registration plate lamp issues | 3 |
Offside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Nearside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 2 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 2 |
Offside Headlamp not working on main beam |1.7.5a| | 2 |
Registration plate issues | 2 |
Front Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Front Windscreen wiper not operating automatically when switched on |8.2.1b| | 2 |
Nearside Side repeater not working |1.4.A.2c| | 2 |
Nearside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 2 |
Parking brake: efficiency below requirements |3.7.B.7| | 2 |
Nearside Front Front constant velocity joint gaiter split |2.5.C.1a| | 2 |
Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Windscreen washer not working | 2 |
Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Nearside Front Headlamp insecure |1.7.3| | 1 |
Nearside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Emissions not tested |8.2.1.2 |d|| | 1 |
Exhaust fumes causing a danger to health of persons on board |6.1.2 |b| |ii|| | 1 |
Exhaust system insecure |6.1.2 |a|| | 1 |
Mechanical brake component has restricted free movement | 1 |
Rear brake application uneven | 1 |
Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
Nearside Front wheel bearing has excessive play |2.5.A.3c| | 1 |
Direction indicators flashing more than 120 times a minute |1.4.A.2g| | 1 |
Nearside Front Side repeater not working |1.4.A.2c| | 1 |
Offside Front Headlamp not working on main beam |1.7.5a| | 1 |
Nearside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Offside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Rear Brake cable has wires broken and is significantly weakened |3.5.1b| | 1 |
Front Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 1 |
Front Exhaust system not adequately supported |7.1.1| | 1 |
Nearside Rear Brake load sensing valve linkage seized |3.6.E.3| | 1 |
Front Windscreen washer control missing |8.2.1a| | 1 |
Offside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Rear Seat belt damaged sufficient to significantly weakened the webbing |5.2.2a| | 1 |
Horn not working |1.6.2a| | 1 |
Rear brake binding | 1 |
Nearside Rear wheel bearing has excessive play |2.6.2| | 1 |
Offside Headlamp excessively deteriorated so that the light output is severely reduced |1.7.5a| | 1 |
Nearside Rear coil spring broken |2.4.C.1a| | 1 |
Nearside Rear Braking system leaking brake pipe | no brakes | |3.6.A.1| | 1 |
Offside Headlamp insecure |1.7.3| | 1 |
Nearside Rear Direction indicator not working |1.4.A.2c| | 1 |
Nearside Front Seat belt anchorage prescribed area is excessively corroded jacking point |5.2.6| | 1 |
Offside Front Seat belt anchorage prescribed area is excessively corroded inside door pillar |5.2.6| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded inner wheel arch x 3 |2.4.A.3| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded inner wheel arch |2.4.A.3| | 1 |
Nearside front brake grabbing severely |3.7.A.2b| | 1 |
Nearside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength in a few places frt and rear of leaf spring (5.3.6 (a) (i)) | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength nxt to leaf spring (5.3.6 (a) (i)) | 1 |
Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i)) | 1 |
Exhaust system insecure (6.1.2 (a)) | 1 |
Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis central to rear (5.3.6 (a) (i)) | 1 |
Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis central to rear (5.3.6 (a) (i)) | 1 |
Offside Side repeater not working |1.4.A.2c| | 1 |
Nearside Front brake disc excessively pitted |3.5.1h| | 1 |
Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Nearside Front Passenger`s seat insecure |6.2.A.1| | 1 |
Nearside Headlamp excessively damaged so that the light output is severely reduced |1.7.5a| | 1 |
Nearside Headlamp insecure |1.7.3| | 1 |
Fuel system component insecure |7.2.1| | 1 |
Nearside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Offside Front Steering component mounting prescribed area is excessively corroded |2.2.C.1h| | 1 |
Windscreen wiper blade insecure | 1 |
Offside Rear Rear position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Front Seat belt anchorage prescribed area is inadequately repaired |5.2.6| | 1 |
Offside Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Front Exhaust has a major leak of exhaust gases down pipe (6.1.2 (a)) | 1 |
Offside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner arch (6.2.2 (d) (i)) | 1 |
Offside Front Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |
Nearside Rear Direction indicator adversely affected by the operation of another lamp indicator flash on side light (4.4.3 (b)) | 1 |
Nearside Rear Stop lamp(s) adversely affected by the operation of another lamp flashes on indicator (4.3.3 (b)) | 1 |
Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
Reversing lamp inoperative (4.6.1 (a)) | 1 |
Battery insecure and likely to fall from carrier (4.13 (a) (ii)) | 1 |
Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner out rigger (6.2.2 (d) (i)) | 1 |
Nearside Front Shock absorbers has a serious fluid leak | 1 |
Offside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting arch (6.2.2 (d) (i)) | 1 |
Nearside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting arch (6.2.2 (d) (i)) | 1 |
Offside Front Headlamp insecure (4.1.1 (c)) | 1 |
Nearside Front Headlamp insecure (4.1.1 (c)) | 1 |
Nearside Front Headlamp aim not tested (4.1.2 (b)) | 1 |
Offside Front Headlamp aim not tested (4.1.2 (b)) | 1 |
Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
Emissions not tested fuel filler neck insecure (smell fumes) (8.2.1.2 (d)) | 1 |
Exhaust system insecure hangers missing (6.1.2 (a)) | 1 |
Offside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
Fuel pipe so insecure there is a risk of fire filler neck pipe deteriorated (6.1.3 (a) (ii)) | 1 |
Offside Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
Nearside Front Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i)) | 1 |
Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength under bonnet (5.3.6 (a) (i)) | 1 |
Front Inner Brake disc significantly and obviously worn (1.1.14 (a) (i)) | 1 |
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
Headlamp insecure |1.7.3| | 1 |
Nearside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Brake hose has insufficient room to move | 1 |
Rear wheel bearing rough when rotated |2.6.1| | 1 |
Nearside Front Headlamp aim beam image kick up to the offside |1.8| | 1 |
Front Fuel pipe leaking |7.2.3| | 1 |
Nearside Side repeater not working |4.4.1 |a| |ii|| | 1 |
Offside Side repeater not working |4.4.1 |a| |ii|| | 1 |
Offside Headlamp excessively damaged so that the light output is severely reduced |1.7.5a| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Offside Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Nearside Front Seat belt locking mechanism does not secure or release |5.2.5a| | 1 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Front constant velocity joint gaiter insecurely mounted to its housing |2.5.C.1a| | 1 |
Rear Exhaust system not adequately supported |7.1.1| | 1 |
Offside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 1 |
Exhaust system not adequately supported |7.1.1| | 1 |
Nearside Front Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
Nearside Outer Front constant velocity joint gaiter insecurely mounted to its housing |2.5.C.1a| | 1 |
Centre Exhaust system not adequately supported |7.1.1| | 1 |
Brake load sensing valve seized |3.6.E.3| | 1 |
Brake pipe inadequately supported |3.6.B.1| | 1 |