| Most common failures | No# failures |
|---|
| Headlamp aim out of alignment | 19 |
| Rear reflector on motorcycle missing |1.4.1| | 11 |
| Drive chain excessively loose |6.2.1d| | 11 |
| Nearside Front shock absorber seal failed and leaking oil |2.3.3| | 10 |
| Registration plate issues | 8 |
| Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 6 |
| Offside Front Brake disc|s| friction surface contaminated by oil or grease |3.2.A1k| | 5 |
| Offside Front shock absorber seal failed and leaking oil |2.3.3| | 5 |
| Throttle operating incorrectly |6.2.1f| | 4 |
| Rear position lamp does not illuminate immediately when it is switched on |1.1.3a| | 4 |
| Drive chain worn to excess |6.2.1e| | 4 |
| Front Roller brake test indicates a binding brake |3.3.A1a| | 4 |
| Rear Floor brake test indicates a binding brake |3.3.C2c| | 3 |
| Front Brake fluid reservoir fluid level dangerously low |3.2.B1d| | 3 |
| Drive chain excessively tight |6.2.1d| | 3 |
| Offside Front Footrest insecure |6.2.1a| | 3 |
| Offside Front Direction indicator not working |1.5.1c| | 3 |
| Rear Brake pedal has inadequate reserve travel |3.1.3b| | 3 |
| Horn not working |1.7.3a| | 3 |
| Front Floor brake test indicates a binding brake |3.3.C2c| | 2 |
| Front shock absorber seal failed and leaking oil |2.3.3| | 2 |
| Rear Brake disc|s| excessively scored |3.2.A1l| | 2 |
| Rear Stop lamp not working |4.3.1 |a| |ii|| | 2 |
| Rear Roller brake test indicates a binding brake |3.3.A1a| | 2 |
| Headlamp insecure |1.2.3b| | 2 |
| Front Front wheel bearings have excessive free play |2.3.5b| | 2 |
| Nearside Front Direction indicator not working |1.5.1c| | 2 |
| Offside Front Front shock absorber seal failed and leaking oil |2.3.3| | 2 |
| Steering headbearing has excessive free play |2.2.2| | 2 |
| Offside Front Brake pipe union leaking fluid |3.2.B4| | 2 |
| Front Brake component has restricted free movement and operation is likely to be impeded |3.2.A1h| | 2 |
| Front Brake disc|s| friction surface contaminated by oil or grease |3.2.A1k| | 2 |
| Offside Rear Locking device|s| not correctly fitted which may make the motor bicycle dangerous to ride |6.2.1h| | 1 |
| Headlamp light intensity severely reduced (4.1.4 (a)) | 1 |
| Rear reflector missing (4.8.2 (a) (ii)) | 1 |
| Nearside Handlebar handgrip not secure to handlebars. |2.1.1c| | 1 |
| Exhaust has part of the system missing |7.1.1a| | 1 |
| Headlamp not working on main beam |4.1.1 |a| |ii|| | 1 |
| Front Brake indicates excessive fluctuation of brake effort |1.2.1 |e|| | 1 |
| Steering headbearing has excessive wear or free play |2.2.2 |f| |i|| | 1 |
| Front Wheel bearing has excessive play |5.1.3 |a| |i|| | 1 |
| Headlamp dipped beam affected by the operation of another lamp |1.2.2c| | 1 |
| Nearside Front Shock absorber has a serious fluid leak (5.3.2 (b)) | 1 |
| Horn not working (7.7 (a) (ii)) | 1 |
| Front Brake grabbing severely (1.2.1 (c)) | 1 |
| Front Brake caliper leaking Leaking from bleed nipple (1.1.16 (b) (i)) | 1 |
| Offside Front Throttle has a significant change in engine speed whilst moving the steering from lock to lock |2.1.4| | 1 |
| Nearside Front Handlebar handgrip not secure to handlebars. |2.1.1c| | 1 |
| Rear Stop lamp remains on when the brake is released |1.3.1e| | 1 |
| Drive chain so loose it is likely to fail (6.1.7 (c) (ii)) | 1 |
| Rear Brake hose is likely to be fouled or trapped by moving parts |3.2.B2c| | 1 |
| Front Shock absorber has a serious fluid leak (5.3.2 (b)) | 1 |
| Rear Brake excessively binding (1.2.1 (f)) | 1 |
| Horn sound not in accordance with requirements (7.7 (c)) | 1 |
| Brake performance unable to be tested (1.2.1 (g)) | 1 |
| Nearside Front Direction indicator insecure |1.5.3b| | 1 |
| Front Roller brake test indicates a sticking brake |3.3.A1a| | 1 |
| Rear Brake pedal insecure |3.1.2a| | 1 |
| Front Brake disc|s| is excessively distorted |3.2.A1m| | 1 |
| Front Roller brake test indicates a severely grabbing brake |3.3.A1b| | 1 |
| Offside Rear Exhaust noise is clearly in excess of that emitted by a similar motor bicycle fitted with a standard silencer in average condition |7.1.2| | 1 |
| Nearside Rear Footrest missing |6.2.1a| | 1 |
| Offside Rear Footrest missing |6.2.1a| | 1 |
| Steering headbearing excessively stiff or notchy Head bearings notch in middle of steering |2.2.2 |f| |i|| | 1 |
| Rear Brake effort inadequate at a wheel Rear brake lever travel to much |1.2.1 |a| |i|| | 1 |
| Front suspension assembly component cracked top steering yoke cracked around left hand clamp |2.3.1| | 1 |
| Fuel pipe leaking |7.2.1a| | 1 |
| Nearside Front Roller brake test indicates a binding brake |3.3.A1a| | 1 |
| Offside Front Roller brake test indicates a binding brake |3.3.A1a| | 1 |
| Footrest missing |6.2.1a| | 1 |
| Rear Brake disc|s| excessively worn |3.2.A1l| | 1 |
| Headlamp at least one does not illuminate on dipped beam |1.2.2a|i|| | 1 |
| Nearside Indicator tell tale not functioning |1.5.2| | 1 |
| Offside Indicator tell tale not functioning |1.5.2| | 1 |
| Fuel cap mounting flange/sealing method defective |7.2.2c| | 1 |
| Steering control handlebar movement restricted by trapped cables |2.1.2c| | 1 |
| Rear Rear reflector on motorcycle missing |1.4.1| | 1 |
| Front Headlamp at least one does not illuminate on main beam |1.2.2a|ii|| | 1 |
| Centre Front shock absorber seal failed and leaking oil |2.3.3| | 1 |
| Rear Rear suspension bearing has excessive free play |2.4.A2a|i|| | 1 |
| Front Headlamp insecure |1.2.3b| | 1 |
| Front Brake disc contaminated |1.1.14 |b|| | 1 |
| Riders seat insecure |6.2.5 |a| |ii|| | 1 |
| Rear Brake fluid reservoir fluid not visible (1.1.10 (d) (iii)) | 1 |
| Roller brake test No brake control achieves an efficiency of 30%. |3.3.A2a| | 1 |
| Offside Front Brake lever cannot be applied smoothly |3.1.3d| | 1 |
| Offside Rear Brake pedal cracked |3.1.2c| | 1 |
| Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| Offside Front Footrest insecure (6.2.12 (a)) | 1 |
| Headlamp aim not tested |1.6| | 1 |
| Nearside Front Front shock absorber seal failed and leaking oil |2.3.3| | 1 |
| Centre Rear Rear reflector on motorcycle missing |1.4.1| | 1 |
| Headlamp at least one does not illuminate on main beam |1.2.2a|ii|| | 1 |
| Rear Roller brake test indicates a sticking brake |3.3.A1a| | 1 |
| Front Brake excessively binding (1.2.1 (f)) | 1 |
| Drive chain so worn it is likely to fail (6.1.7 (c) (ii)) | 1 |
| Drive chain excessively loose (6.1.7 (c) (i)) | 1 |
| Stop lamp remains on when the brakes are released | 1 |
| Front Steering headbearing has excessive free play |2.2.2| | 1 |
| Handlebar handgrip not secure to handlebars. |2.1.1c| | 1 |
| Nearside Rear Direction indicator not working |4.4.1 |a| |ii|| | 1 |
| Offside Rear Direction indicator obviously incorrectly positioned i.e broken |4.4.3 |a|| | 1 |
| Front Brake lever mounting cracked |3.1.2c| | 1 |
| Brake component is excessively corroded |3.1.5| | 1 |
| Front Brake pipe union leaking fluid |3.2.B4| | 1 |
| Rear wheel bearings are excessively rough |2.4.A.2c| | 1 |
| Registration plate lamp issues | 1 |
| Rear reflector missing |4.8.2 |a| |ii|| | 1 |
| Rear Brake component has restricted free movement and operation is likely to be impeded |3.2.A1h| | 1 |
| Rear Decelerometer brake test indicates a sticking brake |3.3.E1d| | 1 |
| Rear Exhaust has part of the system missing |7.1.1a| | 1 |
| Front Front shock absorber seal failed and leaking oil |2.3.3| | 1 |
| Front Front suspension has inadequate damping effect. |2.3.6c| | 1 |
| Handlebar mounting clamp bolt loose |2.1.1a| | 1 |
| Front suspension has inadequate damping effect. |2.3.6c| | 1 |
| Exhaust excessively deteriorated |7.1.1a| | 1 |
| Nearside Front Brake caliper|s| securing bolt|s| loose |3.2.A1j| | 1 |
| Nearside Front Brake disc|s| friction surface contaminated by oil or grease |3.2.A1k| | 1 |
| Exhaust noise is clearly in excess of that emitted by a similar motor bicycle fitted with a standard silencer in average condition |7.1.2| | 1 |
| Exhaust mounting does not fully support the exhaust system |7.1.1.c| | 1 |
| Rear wheel bearings have excessive free play |2.4.A.2c| | 1 |
| Front Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 1 |
| Front position lamp damaged and function impaired |1.1.1b| | 1 |
| Nearside Footrest insecure |6.2.1a| | 1 |
| Front Headlamp dipped beam flickers when tapped lightly by hand |1.2.2c| | 1 |
| Rear wheel rotation likely to be impeded |6.2.1b| | 1 |
| Front Steering movement excessively `notchy` with the wheel raised |2.2.1b| | 1 |
| Front wheel bearings have excessive free play |2.3.5b| | 1 |
| Front wheel bearings are excessively rough |2.3.5b| | 1 |
| Front Roller brake test indicates a severely juddering brake |3.3.A1b| | 1 |
| Front Brake disc|s| has excessive run out |3.2.A1m| | 1 |
| Steering movement excessively `notchy` with the weight on the lower bearing |2.2.1a| | 1 |
| Steering movement excessively `notchy` with the wheel raised |2.2.1b| | 1 |