Most common failures | No# failures |
---|
Brake hose excessively deteriorated | 3 |
Windscreen wiper does not clear the windscreen effectively | 3 |
Brake pipe excessively corroded | 3 |
Headlamp aim out of alignment | 2 |
Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
Brakes imbalanced across an axle | 2 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Rear fog lamp switch insecure |1.3.1a| | 1 |
Registration plate lamp issues | 1 |
Centre Exhaust system not adequately supported |7.1.1| | 1 |
Offside Outer Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Parking brake lever has no reserve travel |3.1.6b| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Rear Rear reflector missing |1.5.1a| | 1 |
Offside Rear fog lamp not working |1.3.2b| | 1 |
Windscreen has damage | 1 |
Offside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Registration plate issues | 1 |
Nearside Front Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Rear parking brake recording little or no effort | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |
Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Offside Rear Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Offside Front Suspension component mounting prescribed area is inadequately repaired (5.3.6 (a) (i)) | 1 |
Offside Front Seat belt anchorage prescribed area is inadequately repaired (7.1.1 (a) (i)) | 1 |
Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
Offside Front Service brake excessively binding (1.2.1 (f)) | 1 |
Nearside Front Service brake excessively binding (1.2.1 (f)) | 1 |
Offside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i)) | 1 |
Position lamp switch allows the rear position lamps to be switched off when the headlamps are on Switch faulty. (4.2.2 (a)) | 1 |
Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |