| Most common failures | No# failures |
|---|
| Rear brake binding | 5 |
| Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor to chassis leg by rear spring mounting |5.3.6 |a| |i|| | 2 |
| Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Brake pipe excessively corroded | 2 |
| Brakes imbalanced across an axle | 2 |
| Offside Rear Anti-roll bar linkage insecure |2.4.G.1| | 1 |
| Offside Rear Shock absorber insecure |2.7.2b| | 1 |
| Parking brake: efficiency below requirements |3.7.B.7| | 1 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Front An item not tested |Manual| | 1 |
| Nearside Front Headlamp aim not tested |1.8.A.1c| | 1 |
| Nearside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
| Offside Front wheel bearing has excessive play |2.5.A.3c| | 1 |
| Nearside Rear Leaf spring has a deteriorated shackle pin rubber bush resulting in excessive movement |2.4.B.2| | 1 |
| Offside Rear Leaf spring has a deteriorated shackle pin rubber bush resulting in excessive movement |2.4.B.2| | 1 |
| Offside front brake grabbing severely |3.7.A.2b| | 1 |
| Offside Front Brake hydraulic reservoir cap missing |3.6.G.1a| | 1 |
| Battery insecure |1.9.1| | 1 |
| Service brake: efficiency below requirements |3.7.B.7| | 1 |
| Nearside front brake juddering severely |3.7.A.2b| | 1 |
| Brake servo retaining device insecure |3.6.A.2d| | 1 |
| Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Offside Rear Body has a sharp edge caused by damage |6.1.C.1| | 1 |
| Stop lamp not working |1.2.1b| | 1 |