Most common failures | No# failures |
---|
Headlamp aim out of alignment | 6 |
Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c)) | 5 |
Registration plate lamp issues | 4 |
Offside Front suspension has excessive play in a upper suspension ball joint |2.5.B.1a| | 4 |
Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b)) | 3 |
Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b)) | 3 |
Nearside Front wheel bearing has excessive play |2.5.A.3c| | 2 |
Nearside Steering rack gaiter split |2.2.D.2d| | 2 |
Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone `A` |8.3.1b| | 2 |
Nearside Front Direction indicator incorrect colour |1.4.A.2f| | 2 |
Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3| | 2 |
Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 2 |
Nearside Rear Radius arm has excessive play in a pin/bush |2.4.G.2| | 2 |
Parking brake: efficiency below requirements |3.7.B.7| | 2 |
Nearside Front suspension has excessive play in a upper suspension ball joint |2.5.B.1a| | 2 |
Nearside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 2 |
Rear brake application uneven | 1 |
Offside Rear fog lamp not working |1.3.2b| | 1 |
Offside Rear Sub-frame corroded and seriously weakened |2.4.G.1| | 1 |
Nearside Front Upper Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Offside Front Front wheel bearing has excessive play |2.5.A.3c| | 1 |
Offside Front Lower Subframe mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Suspension has inadequate clearance with the bump stop osf |2.4.A.1a| | 1 |
Suspension component mounting prescribed area is excessively corroded osr lower. inner wheel arch. |2.4.A.3| | 1 |
Front wheel bearing has excessive play nsf |2.5.A.3c| | 1 |
Offside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Front brake disc in such a condition that it is seriously weakened | 1 |
Exhaust emits visible black smoke at idle (8.2.1.2 (f)) | 1 |
Exhaust emits excessive dense blue smoke during acceleration (8.2.1.2 (g)) | 1 |
Offside Rear Exhaust system not adequately supported |7.1.1| | 1 |
Service brake excessively binding All Wheels (1.2.1 (f)) | 1 |
Offside Rear Brake pipe connection leaking on a hydraulic braking system N/S pipe (1.1.11 (b) (ii)) | 1 |
Horn not working (7.7 (a) (ii)) | 1 |
Front Exhaust has a major leak of exhaust gases down pipe to cat connecting pipe leaking from all 3 joins (6.1.2 (a)) | 1 |
Drivers seat insecure cannot be secured positively to the floor (6.2.5 (a) (ii)) | 1 |
Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i)) | 1 |
Nearside Rear Wheel bearing has excessive play (5.1.3 (a) (i)) | 1 |
Offside Rear Wheel bearing has excessive play (5.1.3 (a) (i)) | 1 |
Offside Front Track rod end seriously misaligned mounting arm on top of hub loose - bolts finger tight & locking tabs not used! (2.1.3 (e)) | 1 |
Offside Front Track rod end ball joint worn to the extent there is a serious risk of detachment mounting arm on top of hub loose - bolts finger tight & locking tabs not used! (2.1.3 (b) (ii)) | 1 |
Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt upper arm, inner joint gaiter insecure (5.3.4 (b) (ii)) | 1 |
Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a)) | 1 |
Offside Front Drivers seat insecure (6.2.5 (a) (ii)) | 1 |
Rear Passengers seat backrest cannot be secured in the upright position. (6.2.6 (a) (i)) | 1 |
Supplementary restraint system warning lamp indicates a fault (7.1.6 (a)) | 1 |
Nearside Front Outer Track rod end ball joint has excessive play (2.1.3 (b) (i)) | 1 |
Offside Rear Valve stem seriously damaged (5.2.3 (j)) | 1 |
Offside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength 30cm of subframe mount (5.3.6 (a) (i)) | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength 30cm of subframe mount (5.3.6 (a) (i)) | 1 |
Offside Electrical wiring insecure and in contact with sharp edges Battery cable rubbing on boot floor (4.11 (a) (ii)) | 1 |
Offside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Rear Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Offside Steering rack gaiter split |2.2.D.2d| | 1 |
Nearside Side repeater incorrect colour |1.4.A.2f| | 1 |
Offside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Offside Rear Suspension arm pin or bush excessively worn Radius arm bearing worn (5.3.4 (a) (i)) | 1 |
Rear Sub-frame corroded to the extent that the rigidity of the assembly is significantly reduced |6.1.1 |c| |i|| | 1 |
Nearside Front Direction indicator incorrect colour (4.4.3 (a)) | 1 |
Offside Front Direction indicator incorrect colour (4.4.3 (a)) | 1 |
Offside Rear Brake cable damaged (1.1.15 (a)) | 1 |
Nearside Rear Brake cable damaged snapped (1.1.15 (a)) | 1 |
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
Bonnet cannot be secured in the closed position (3.1 (b) (i)) | 1 |
Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a)) | 1 |
Offside Front Lower Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced jacking point holed (6.1.1 (c) (i)) | 1 |
Nearside Rear Service brake excessively binding (1.2.1 (f)) | 1 |
Brakes imbalanced across an axle | 1 |
Fuel system component leaking |7.2.3| | 1 |
Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
Exhaust emissions carbon monoxide content at idle excessive |7.3.D.4| | 1 |
Exhaust catalytic converter missing where one was fitted as standard |7.1.3| | 1 |
Offside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
Offside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Nearside Front Sub-frame attachment rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Offside Front Sub-frame attachment rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Front brake disc excessively scored |3.5.1h| | 1 |
Front brake application uneven | 1 |
Rear parking brake recording little or no effort | 1 |
Offside Front Sub-frame rubber bush bonding deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
Offside Rear Radius arm has excessive play in a pin/bush |2.4.G.2| | 1 |
Offside Headlamps matched pair are not the same colour |1.7.6| | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Front Upper engine mounting deteriorated resulting in excessive movement |6.1.D.1a| | 1 |
Offside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |