Most common failures | No# failures |
---|
Parking brake: efficiency below requirements |3.7.B.7| | 8 |
Brakes imbalanced across an axle | 7 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 6 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Registration plate lamp issues | 3 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Windscreen wiper does not clear the windscreen effectively | 3 |
Registration plate issues | 2 |
Offside Front wheel bearing has excessive play |2.5.A.3c| | 2 |
Nearside Steering rack gaiter split |2.2.D.2d| | 2 |
Headlamp aim out of alignment | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded floor to sill |2.4.A.3| | 1 |
Offside Rear Subframe mounting prescribed area is fractured outer sill |2.4.A.3| | 1 |
Offside Rear Subframe mounting prescribed area is excessively corroded inner wing |2.4.A.3| | 1 |
Nearside Rear Suspension arm rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Brake hydraulic reservoir fluid level below minimum level |3.6.G.1b| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Bonded suspension unit bonding failed and part of unit is likely to become displaced |2.4.F.2| | 1 |
Centre Exhaust system not adequately supported |7.1.1| | 1 |
Rear Exhaust system not adequately supported |7.1.1| | 1 |
Nearside Front Lower Suspension component mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Offside Front Lower Suspension arm ball joint dust cover missing |2.4.G.2| | 1 |
Nearside Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
Front brake application uneven | 1 |
Fuel cap/sealing device sealing washer missing |7.2.4c| | 1 |
Nearside Obligatory mirror insecure |8.1.1| | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Windscreen wiper blade deteriorated |8.2.2| | 1 |
Rear Exhaust mounting missing |7.1.1b| | 1 |
Front brake disc in such a condition that it is seriously weakened | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Exhaust emissions hydrocarbon content excessive |7.3.B.1b| | 1 |
Offside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Direction indicators not working |1.4.A.2c| | 1 |
Offside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Nearside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Nearside Front Upper Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Offside Front Upper Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Offside Rear Suspension arm rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Hazard warning tell tale not working correctly |1.4.B.1e| | 1 |
Exhaust system not adequately supported |7.1.1| | 1 |
Nearside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Offside Rear Towbar excessively corroded within 30cm of towbar mounting valance and wheel box (6.1.6 (i) (i)) | 1 |
Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
Nearside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
Horn not working (7.7 (a) (ii)) | 1 |
Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Both rear stop ends (5.3.6 (a) (i)) | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i)) | 1 |
Oil leaking continuously from engine posing a serious risk to road safety (8.4.1 (a) (ii)) | 1 |
Offside Front Lower Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
Nearside Front Upper Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Both rear floor pans (5.3.6 (a) (i)) | 1 |
Nearside Front Service brake excessively binding (1.2.1 (f)) | 1 |
Offside Rear Brake valve leaking cylinder (1.1.7 (d) (i)) | 1 |
Steering rack gaiter missing or no longer prevents the ingress of dirt both (2.1.3 (g) (ii)) | 1 |
Main beam `tell-tale` not working |1.7.4c| | 1 |
Rear brake binding | 1 |
Direction indicators flashing less than 60 times a minute |1.4.A.2g| | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Nearside Inner Front Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Service brake is causing the steering wheel to severely pull one way |3.7.C.2| | 1 |
Nearside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Rear Exhaust has a major leak of exhaust gases Silencer box (6.1.2 (a)) | 1 |
Nearside front brake binding |3.7.B.1| | 1 |
Offside front brake binding |3.7.B.1| | 1 |
Offside Steering rack gaiter split |2.2.D.2d| | 1 |
Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
Nearside Front wheel bearing has excessive play |2.5.A.3c| | 1 |
Nearside Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
Nearside Front Direction indicator not working (4.4.1 (a) (ii)) | 1 |
Steering rack has excessive free play detected at the steering wheel to the extent that safe steering is affected (steering rack fitted) (2.3 (a) (ii)) | 1 |
Nearside Front Steering rack has excessive free play detected at the steering wheel (steering rack fitted) rack end (2.3 (a) (i)) | 1 |
Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b)) | 1 |
Fuel system component leaking excessively or a risk of fire (6.1.3 (b) (ii)) | 1 |
Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
Nearside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) | 1 |
Nearside Rear Parking brake inoperative on one side (1.4.1 (a)) | 1 |
Offside Front Brake pipe connection leaking on a hydraulic braking system (1.1.11 (b) (ii)) | 1 |
Offside Rear Direction indicator not working (4.4.1 (a) (ii)) | 1 |
Offside Front Service brake excessively binding (1.2.1 (f)) | 1 |