| Most common failures | No# failures |
|---|
| Brakes imbalanced across an axle | 6 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
| Windscreen wiper does not clear the windscreen effectively | 3 |
| Headlamp aim out of alignment | 3 |
| Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Nearside Rear position lamp|s| not working |1.1.A.3b| | 2 |
| Exhaust emits an excessive level of metered smoke for a non-turbo charged engine |7.4.B.3b| | 2 |
| Brake pipe excessively corroded | 2 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Nearside Front Shock absorber has a serious fluid leak |2.7.3| | 1 |
| Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
| Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Emissions not tested |7.0| | 1 |
| Brake has no servo assistance |3.3.B.2| | 1 |
| Registration plate lamp issues | 1 |
| Nearside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Brake pedal creeps down when held under pressure |3.3.B.1a| | 1 |
| Offside Obligatory mirror is incapable of being adjusted to provide an adequate view to the rear |8.1.2b| | 1 |
| Nearside Front Upper Shock absorber has an excessively worn bush |2.7.4| | 1 |
| Offside Rear Upper Shock absorber has an excessively worn bush |2.7.4| | 1 |
| Fuel cap/sealing device does not fasten securely by positive means |7.2.4b| | 1 |
| Nearside Front Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
| Nearside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f)) | 1 |
| Offside Headlamp insecure (4.1.1 (c)) | 1 |
| Fluid leaking continuously posing a serious risk to road safety diesel |8.4.1 |a| |ii|| | 1 |
| Offside Front Wheel bearing rough when rotated and slight play |5.1.3 |b| |i|| | 1 |
| Offside Rear Shock absorbers has a serious fluid leak | 1 |
| Fuel system component leaking (6.1.3 (b) (i)) | 1 |
| Battery insecure and likely to fall from carrier (4.13 (a) (ii)) | 1 |
| Offside Front Suspension component mounting prescribed area is inadequately repaired Inner arch (5.3.6 (a) (i)) | 1 |
| Offside Front Suspension component mounting prescribed area fractured significantly reducing structural strength inner sill (5.3.6 (a) (i)) | 1 |
| Offside Rear Suspension component mounting prescribed area fractured significantly reducing structural strength inner sill (5.3.6 (a) (i)) | 1 |
| Horn not working (7.7 (a) (ii)) | 1 |
| Registration plate issues | 1 |
| Nearside Front Direction indicator not working (4.4.1 (a) (ii)) | 1 |
| Rear Direction indicator not working (4.4.1 (a) (ii)) | 1 |
| Rear fog lamp missing (4.5.1 (a) (ii)) | 1 |
| Bonnet primary retaining device insecure (3.1 (c)) | 1 |
| Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength Spring hanger - BOTH (5.3.6 (a) (i)) | 1 |
| Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Rear fog lamp not working |4.5.1 |a| |ii|| | 1 |
| Battery insecure and likely to fall from carrier |4.13 |a| |ii|| | 1 |
| Exhaust emissions exceed level of metered smoke for a non-turbo charged engine |8.2.2.2 |b|| | 1 |
| Windscreen washer not working | 1 |
| Offside Front Shock absorber has negligible damping effect |2.7.5| | 1 |
| Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement |7.2.4b| | 1 |
| Nearside Front Front wheel bearing rough when rotated |2.5.A.2| | 1 |
| Nearside Rear Brake cable has restricted free movement |3.5.1k| | 1 |
| Offside Front Obligatory mirror seriously damaged, affecting the rear view |8.1.2a| | 1 |
| Nearside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
| Offside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
| Nearside Front Lower Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
| Offside Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
| Offside front brake binding |3.7.B.1| | 1 |
| Front brake application uneven | 1 |
| Rear brake binding | 1 |
| Rear parking brake recording little or no effort | 1 |
| Nearside Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
| Parking brake: efficiency below requirements |3.7.B.7| | 1 |
| Offside Front Obligatory mirror seriously deteriorated, affecting the rear view |8.1.2a| | 1 |
| Horn not working |1.6.2a| | 1 |
| Offside Rear Brake load sensing valve linkage seized |3.6.E.3| | 1 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Rear Suspension component mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
| Offside Rear Suspension component mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
| Nearside Rear Seat belt anchorage prescribed area is inadequately repaired |5.2.6| | 1 |
| Offside Seat belt anchorage prescribed area is inadequately repaired |5.2.6| | 1 |
| Nearside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Brake pedal anti-slip provision missing |3.3.A.1b| | 1 |
| Rear Statutory seat belt missing |5.1.1| | 1 |
| Offside Windscreen wiper not operating over a large enough area to give an adequate view |8.2.1c| | 1 |
| Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
| Offside Rear passenger seat cannot be secured in the upright position. |6.2.3| | 1 |