Most common failures | No# failures |
---|
Headlamp aim out of alignment | 5 |
Registration plate lamp issues | 3 |
Rear brake application uneven | 2 |
Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Front brake application uneven | 1 |
Nearside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Horn not working |1.6.2a| | 1 |
Driver`s seat insecure |6.2.A.1| | 1 |
Front passenger seat insecure |6.2.3| | 1 |
Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Brake pedal creeps down when held under pressure |3.3.B.1a| | 1 |
Nearside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Windscreen wiper does not clear the windscreen effectively | 1 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 1 |
Rear parking brake recording little or no effort | 1 |
Nearside Rear Braking system leaking |3.6.A.1| | 1 |
Nearside Rear Direction indicator adversely affected by the operation of another lamp |1.4.A.2h| | 1 |
Rear fog lamp not working |1.3.2b| | 1 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded chassis |2.4.A.3| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded inner arch in 2 places |2.4.A.3| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded panel |2.4.A.3| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded inner arch |2.4.A.3| | 1 |
Battery insecure |1.9.1| | 1 |
Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Exhaust system not adequately supported |7.1.1| | 1 |
Brakes imbalanced across an axle | 1 |
Stop lamp not working Both sides |1.2.1b| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded chassis holed in 2 places |2.4.A.3| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded chassis/outrigger holed |2.4.A.3| | 1 |
Exhaust system not adequately supported center rubber broken |7.1.1| | 1 |