Most common failures | No# failures |
---|
Brakes imbalanced across an axle | 3 |
Offside Front front brake binding |3.7.B.1| | 2 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
Headlamp aim out of alignment | 1 |
Horn not working |1.6.2a| | 1 |
Windscreen wiper blade deteriorated |8.2.2| | 1 |
Headlamp aim beam image kick up to the offside |1.6.B1| | 1 |
Nearside Front front brake binding |3.7.B.1| | 1 |
Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Headlamp excessively damaged so that the light output is severely reduced |1.7.5a| | 1 |
Offside Rear fog lamp not working |1.3.2b| | 1 |
Windscreen wiper does not clear the windscreen effectively | 1 |
Rear Exhaust system not adequately supported |7.1.1| | 1 |
Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
Battery insecure and likely to cause a short circuit Excessive corrosion to battery location plate/N/S/F Inner wing (4.13 (a) (ii)) | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Chassis/Rear leaf spring mounting area (5.3.6 (a) (i)) | 1 |
Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i)) | 1 |
Nearside Front Steering locking device ineffective Nut loose (2.1.3 (d)) | 1 |
Offside Front Steering locking device ineffective Nut loose (2.1.3 (d)) | 1 |
Nearside Rear Stop lamp not working |1.2.1b| | 1 |
Offside Front Windscreen wiper not operating automatically when switched on |8.2.1b| | 1 |
Nearside Front Windscreen wiper not operating automatically when switched on |8.2.1b| | 1 |
Centre Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Offside Front Lower Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Brake pipe excessively corroded | 1 |
Offside Outer Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Exhaust emits an excessive level of metered smoke for a non-turbo charged engine |7.4.B.3b| | 1 |
Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Upper Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |