Most common failures | No# failures |
---|
Registration plate lamp issues | 12 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 8 |
Windscreen wiper does not clear the windscreen effectively | 8 |
Brake pipe excessively corroded | 6 |
Headlamp aim out of alignment | 6 |
Offside Front position lamp|s| not working |1.1.A.3b| | 6 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 5 |
Brake hose excessively deteriorated | 4 |
Offside Front Front constant velocity joint gaiter split |2.5.C.1a| | 4 |
Offside Rear fog lamp not working |1.3.2b| | 4 |
Nearside Stop lamp not working |1.2.1b| | 4 |
Offside Stop lamp not working |1.2.1b| | 4 |
Brake pedal anti-slip provision missing |3.3.A.1b| | 3 |
Nearside Headlamp not working on main beam |1.7.5a| | 3 |
Offside Headlamp not working on main beam |1.7.5a| | 3 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 3 |
Nearside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 3 |
Offside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Offside Front Shock absorber has a serious fluid leak |2.7.3| | 3 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Front brake disc in such a condition that it is seriously weakened | 3 |
Brakes imbalanced across an axle | 2 |
Offside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 2 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 2 |
Service brake: efficiency below requirements |3.7.B.7| | 2 |
Offside rear brake recording little or no effort |3.7.B.5a| | 2 |
Fuel cap/sealing device sealing washer deteriorated |7.2.4c| | 2 |
Offside Front Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 2 |
Registration plate issues | 2 |
Parking brake lever has no reserve travel |3.1.6b| | 2 |
Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 2 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 2 |
Offside Front wheel bearing rough when rotated |2.5.A.2| | 2 |
Offside Stop lamp adversely affected by the operation of another lamp |1.2.1f| | 2 |
Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b)) | 2 |
Battery insecure |1.9.1| | 2 |
Nearside Steering rack gaiter split |2.2.D.2d| | 2 |
Nearside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Stop lamp remains on when the brakes are released | 2 |
Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 2 |
Brake master cylinder leaking hydraulic fluid |3.6.G.1f| | 1 |
Front brake disc excessively pitted |3.5.1h| | 1 |
Rear Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
Offside Rear fog lamp excessively damaged so that it is not visible from a reasonable distance |1.3.2d| | 1 |
Nearside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Front Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Nearside wheel cylinder leaking |3.6.A.1| | 1 |
Obligatory mirror does not provide a view to the rear |8.1.2b| | 1 |
Offside front brake binding |3.7.B.1| | 1 |
Offside Front coil spring incomplete |2.4.C.1a| | 1 |
Nearside front brake recording little or no effort |3.7.B.5a| | 1 |
Brake hydraulic reservoir fluid level below minimum level |3.6.G.1b| | 1 |
Brake pedal spongy |3.3.B.1b| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside Front Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Rear Stop lamp not working |1.2.1b| | 1 |
Front Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
Offside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Front Upper Suspension component mounting prescribed area is excessively corroded sturt top |2.4.A.3| | 1 |
Offside Front Upper Suspension component mounting prescribed area is excessively corroded sturt top |2.4.A.3| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded sill |2.4.A.3| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded axle mount |2.4.A.3| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded axle mount |2.4.A.3| | 1 |
Nearside Inner Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Nearside Front coil spring broken |2.4.C.1a| | 1 |
Nearside Front suspension ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Offside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Nearside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Nearside Front Upper Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Rear Front position lamp|s| not working |1.1.A.3b| | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |
Nearside Front Headlamp not working on main beam |1.7.5a| | 1 |
Offside Front Headlamp not working on main beam |1.7.5a| | 1 |
Offside Outer Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 1 |
Rear parking brake recording little or no effort | 1 |
Nearside Outer Prop shaft joint constant velocity boot no longer prevents the ingress of dirt |6.1.7 |g| |ii|| | 1 |
Offside Front Subframe mounting prescribed area is excessively corroded sill closing panel at wheel arch |2.4.A.3| | 1 |
Nearside Front Shock absorber has a serious fluid leak |2.7.3| | 1 |
Brake valve leaking |3.6.A.1| | 1 |
Windscreen washer not working | 1 |
Offside Obligatory mirror seriously damaged, affecting the rear view (3.3 (b) (ii)) | 1 |
Nearside Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
Offside Front Direction indicator incorrect colour |1.4.A.2f| | 1 |
Offside Front Upper Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Rear brake application uneven | 1 |
Front brake application uneven | 1 |
Stop lamp not working |1.2.1b| | 1 |
Offside Front constant velocity joint gaiter insecurely mounted to its housing |2.5.C.1a| | 1 |
Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement |7.2.4b| | 1 |
Nearside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Offside Front constant velocity joint is insecure |2.5.C.1b| | 1 |
Offside Front Seat belt has a cut which has significantly weakened the webbing |5.2.2a| | 1 |
Indicator tell tale inoperative |1.4.A.2a| | 1 |
Horn not working |1.6.2a| | 1 |
Offside Front Vehicle structure has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Steering rack insecure |2.2.B.1a| | 1 |
Nearside Front Steering rack damaged and unserviceable |2.2.C.1d| | 1 |
Offside Front Steering rack damaged and unserviceable |2.2.C.1d| | 1 |
Nearside Front Body or chassis is cracked, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c)) | 1 |
Nearside Position lamp not working (4.2.1 (a) (ii)) | 1 |
Offside Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i)) | 1 |
Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i)) | 1 |
Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
Offside Front Steering rack gaiter split |2.2.D.2d| | 1 |
Nearside Inner Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Nearside Outer Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Brake pedal has insufficient reserve movement |3.3.A.5| | 1 |
Nearside Stop lamp adversely affected by the operation of another lamp |1.2.1f| | 1 |
Offside Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Nearside Rear Direction indicator not working |1.4.A.2c| | 1 |
Offside Rear Seat belt damaged sufficient to obstruct correct operation of the belt |5.2.2a| | 1 |
Nearside Rear Direction indicators incorrect colour |1.4.A.2f| | 1 |
Offside Rear Direction indicators incorrect colour |1.4.A.2f| | 1 |
Nearside Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
Offside Headlamp excessively deteriorated so that the light output is severely reduced |1.7.5a| | 1 |