Most common failures | No# failures |
---|
Headlamp aim out of alignment | 5 |
Registration plate issues | 3 |
Parking brake: efficiency below requirements |3.7.C.1b| | 2 |
Fuel cap/sealing device ineffective |6.1.3 |b| |i|| | 1 |
Offside Rear reflector missing |4.8.2 |a| |ii|| | 1 |
Offside Rear reflector missing |1.5.1a| | 1 |
Parking brake is not capable of being maintained in operation by direct mechanical action only |3.1.2| | 1 |
Parking brake lever is impeded in its travel |3.1.6c| | 1 |
Parking brake efficiency below requirements |3.7.E.1| | 1 |
Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b)) | 1 |
Nearside Rear Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
Offside Rear Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
Stop lamp(s) not working via rear brake leaver (4.3.1 (a) (ii)) | 1 |
Stop lamp|s| not working when front brake operated |4.3.1 |a| |ii|| | 1 |
Stop lamp not working when front brake applied |1.2.1b| | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Central Exhaust has a major leak of exhaust gases part of |7.1.2| | 1 |
Stop lamp not working both o/s and n/s |1.2.1b| | 1 |
Parking brake not fitted on at least two wheels |3.1.1| | 1 |
Headlamp not working on dipped beam fuse was out |1.7.5a| | 1 |
Fuel cap/sealing device sealing washer deteriorated |7.2.4c| | 1 |
Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Rear Anti-roll bar cracked |2.4.G.1| | 1 |
Towbar component insecure |6.6.1| | 1 |
Nearside Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Offside Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Stop lamp not working does not operate correctly |1.2.1b| | 1 |
Windscreen has a combination of minor damage areas which restrict the drivers view plastic screen badly scuffed |8.3.1c| | 1 |
Windscreen washer control missing not fitted |8.2.1a| | 1 |
Windscreen wiper control missing not fitted |8.2.1a| | 1 |
Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
Registration plate lamp issues | 1 |
Horn not working |1.6.2a| | 1 |
Headlamp does not operate immediately when selected on main beam dip switch faulty lights do not remain on |1.7.4a| | 1 |
Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
Offside Front Inner Track rod end ball pin shank loose |2.2.B.1c| | 1 |
Stop lamp(s) not working on front brake control (4.3.1 (a) (ii)) | 1 |
Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |