| Most common failures | No# failures |
|---|
| Brakes imbalanced across an axle | 2 |
| Brake pipe excessively corroded | 2 |
| Registration plate lamp issues | 2 |
| Offside Front Front wheel bearing has excessive play |2.5.A.3c| | 1 |
| Offside Front Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
| Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength |5.3.6 |a| |i|| | 1 |
| Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner/outer sills |5.3.6 |a| |i|| | 1 |
| Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt |6.1.7 |g| |ii|| | 1 |
| Battery insecure |1.9.1| | 1 |
| Nearside Headlamp insecure |1.7.3| | 1 |
| Offside Front Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2| | 1 |
| Nearside Side repeater incorrect colour |1.4.A.2f| | 1 |
| Offside Side repeater incorrect colour |1.4.A.2f| | 1 |
| Brake load sensing valve seized |3.6.E.3| | 1 |
| Nearside Steering rack gaiter split |2.2.D.2d| | 1 |
| Headlamp aim out of alignment | 1 |
| Rear Upper Stop lamp not working |1.2.1b| | 1 |
| Nearside Front Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
| Nearside Front Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
| Nearside Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
| Parking brake: efficiency below requirements |3.7.B.7| | 1 |
| Offside Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
| Nearside Front Direction indicator incorrect colour (4.4.3 (a)) | 1 |
| Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |