Most common failures | No# failures |
---|
Windscreen wiper does not clear the windscreen effectively | 10 |
Headlamp aim out of alignment | 10 |
Registration plate lamp issues | 5 |
Rear fog lamp not working |1.3.2b| | 3 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 2 |
Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |
Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Front Exhaust system not adequately supported |7.1.1| | 1 |
Windscreen wiper not working (3.4 (a)) | 1 |
Offside Front Hydraulic brake calliper leaking (1.1.16 (b) (i)) | 1 |
Nearside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
Brakes imbalanced across an axle | 1 |
Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |
Offside Front Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |
Front Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
Fuel system component leaking filter |7.2.3| | 1 |
Offside Front coil spring broken |2.4.C.1a| | 1 |
Offside Side repeater not working (1.4.A.2c) | 1 |
Nearside Track rod end ball joint has excessive play (2.2.B.1f) | 1 |
Supplementary Restraint System warning lamp indicates a fault |5.4.2| | 1 |
Drivers airbag obviously inoperative (7.1.5 (c)) | 1 |
Rear Electrical wiring likely to touch hot or rotating parts Anti roll bar (4.11 (a) (iii)) | 1 |
Supplementary restraint system warning lamp indicates a fault (7.1.6 (a)) | 1 |
Brake pipe excessively corroded | 1 |
Offside Front Brake pipe excessively damaged (1.1.11 (c)) | 1 |
Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
Nearside Rear Bumper damaged and likely to cause injury when grazed or contacted (6.1.4 (a) (i)) | 1 |
Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Exhaust system insecure (6.1.2 (a)) | 1 |
Nearside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill |6.2.2 |d| |i|| | 1 |
Offside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting box section at rear of inner sill near out rigger (6.2.2 (d) (i)) | 1 |
Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Nearside Headlamp aim not tested (4.1.2 (b)) | 1 |
Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor/inner sill various places (5.3.6 (a) (i)) | 1 |
Offside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor to sill various places (5.3.6 (a) (i)) | 1 |
Offside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill various places (5.3.6 (a) (i)) | 1 |
Nearside Rear Suspension has inadequate clearance with the bump stop |2.4.A.1a| | 1 |
Offside Rear Suspension has inadequate clearance with the bump stop |2.4.A.1a| | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Offside Front Seat belt retracting mechanism defective |5.2.5b| | 1 |