| Most common failures | No# failures |
|---|
| Headlamp aim out of alignment | 4 |
| Brakes imbalanced across an axle | 4 |
| Offside Front wheel bearing has excessive play |2.5.A.3c| | 2 |
| Horn not working |1.6.2a| | 2 |
| Horn not working (7.7 (a)) | 2 |
| Rear brake binding | 2 |
| Windscreen wiper does not clear the windscreen effectively | 2 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 2 |
| Nearside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 2 |
| Nearside Front Headlamp levelling device inoperative (4.1.5 (a)) | 1 |
| Offside Front Headlamp levelling device inoperative (4.1.5 (a)) | 1 |
| Nearside Rear wheel bearing has excessive play |2.6.2| | 1 |
| Parking brake: efficiency below requirements |3.7.B.7| | 1 |
| Nearside Front Shock absorber has a serious fluid leak |2.7.3| | 1 |
| Registration plate lamp issues | 1 |
| Nearside Rear All position lamps not working |1.1.A.3b| | 1 |
| Offside Rear position lamp|s| not working |1.1.A.3b| | 1 |
| Nearside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Offside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Horn not working |7.7 |a| |ii|| | 1 |
| Brake load sensing valve seized and ABS not fitted or inoperative |1.1.17 |c| |ii|| | 1 |
| Nearside Front Wheel bearing has excessive play |5.1.3 |a| |i|| | 1 |
| Brake pipe excessively corroded | 1 |
| Front Exhaust system not adequately supported |7.1.1| | 1 |
| Exhaust system not adequately supported |7.1.1| | 1 |
| Upper All outline marker lamps not working (4.2.1 (a) (ii)) | 1 |
| Nearside Front Suspension component mounting prescribed area excessively damaged significantly reducing structural strength strut turret (5.3.6 (a) (i)) | 1 |
| Offside Front Suspension component mounting prescribed area excessively damaged significantly reducing structural strength strut turret (5.3.6 (a) (i)) | 1 |
| Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Chassis near subframe mounting point . (5.3.6 (a) (i)) | 1 |
| Rear Service brake excessively binding Both Sides (1.2.1 (f)) | 1 |
| Offside Rear Service brake lagging in operation (1.2.1 (d)) | 1 |
| Nearside Upper Front position lamp|s| not working |1.1.A.3b| | 1 |
| Offside Upper Front position lamp|s| not working |1.1.A.3b| | 1 |
| Offside Upper Rear position lamp|s| not working |1.1.A.3b| | 1 |
| Offside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
| Service brake: efficiency below requirements |3.7.B.7| | 1 |
| Nearside Rear Stop lamp not working |1.2.1b| | 1 |
| Offside Rear Stop lamp not working |1.2.1b| | 1 |
| Nearside Steering rack gaiter split |2.2.D.2d| | 1 |
| Nearside front brake binding |3.7.B.1| | 1 |
| Nearside Stop lamp not working |1.2.1b| | 1 |
| Fuel cap/sealing device missing |7.2.4a| | 1 |
| Offside Side repeater not working |1.4.A.2c| | 1 |
| Windscreen washer not working | 1 |
| Nearside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i)) | 1 |
| Rear Floor excessively deteriorated (6.2.4 (a) (i)) | 1 |
| Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outrigger (6.1.1 (c) (i)) | 1 |
| Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) | 1 |
| Brake pedal has insufficient reserve travel (1.1.2 (a)) | 1 |
| Offside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Offside Headlamp light source and lamp not compatible (4.1.4 (c)) | 1 |
| Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill (6.1.1 (c) (i)) | 1 |
| Nearside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Nearside Rear Inner Rear fog lamp switch inoperative (4.5.3 (a)) | 1 |
| Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |