| Most common failures | No# failures |
|---|
| Windscreen wiper does not clear the windscreen effectively | 3 |
| Windscreen washer not working | 2 |
| Brake hose excessively deteriorated | 2 |
| Centre Exhaust system not adequately supported |7.1.1| | 2 |
| Rear brake binding | 2 |
| Rear parking brake recording little or no effort | 2 |
| Offside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Nearside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Registration plate lamp issues | 1 |
| Offside Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
| Stop lamp(s) all not working (4.3.1 (a) (iii)) | 1 |
| Offside Front Side repeater likely to become detached (4.4.1 (c) (ii)) | 1 |
| Offside Battery insecure and likely to fall from carrier (4.13 (a) (ii)) | 1 |
| Brake pipe excessively corroded | 1 |
| Nearside Rear Brake load sensing valve linkage defective and function impaired (1.1.17 (a)) | 1 |
| Front Fuel system component leaking (6.1.3 (b) (i)) | 1 |
| Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
| Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
| Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
| Nearside Front Brake hose leaking |3.6.A.1| | 1 |
| Centre Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Fuel system component leaking |7.2.3| | 1 |
| Offside Front Brake pipe twisted |found during steering lock to lock check| |2.2.D.2b| | 1 |
| Nearside Front Brake pipe fouled by moving parts |3.6.B.2a| | 1 |
| Offside Front Brake pipe inadequately clipped |3.6.B.1| | 1 |
| Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Offside Headlamp not working on main beam |1.7.5a| | 1 |
| Nearside Rear Service brake excessively binding (1.2.1 (f)) | 1 |
| Parking brake is not capable of being maintained in operation by direct mechanical action only |3.1.2| | 1 |
| Offside Rear Service brake excessively binding (1.2.1 (f)) | 1 |
| Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced all around jacking point |6.1.1 |c| |i|| | 1 |
| Offside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
| Horn not working |1.6.2a| | 1 |
| Offside Front Lower Front suspension has excessive movement at a suspension ball joint |2.5.A.1c| | 1 |
| Offside Outer Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
| Nearside Outer Front constant velocity joint gaiter insecurely mounted to its housing |2.5.C.1a| | 1 |
| Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Nearside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Nearside Front Lower Radius arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Exhaust emits an excessive level of metered smoke for a non-turbo charged engine |7.4.B.3b| | 1 |