Most common failures | No# failures |
---|
Service brake efficiency below requirements (1.2.2 (a) (i)) | 2 |
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 2 |
Windscreen wiper does not clear the windscreen effectively | 2 |
Horn not working |1.6.2a| | 2 |
Headlamp aim out of alignment | 2 |
Offside Rear fog lamp not working |1.3.2b| | 2 |
Offside Stop lamp not working |1.2.1b| | 2 |
Rear brake binding | 2 |
Brake pipe excessively corroded | 2 |
Position lamp switch insecure (4.2.2 (b)) | 1 |
Offside Front Side repeater not working (4.4.1 (a) (ii)) | 1 |
Nearside Rear Leaf spring anchor bracket corroded and seriously weakened (5.3.1 (b) (i)) | 1 |
Offside Rear Leaf spring anchor bracket corroded and seriously weakened (5.3.1 (b) (i)) | 1 |
Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced jacking point and step corroded (6.1.1 (c) (i)) | 1 |
Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced jacking point and step corroded (6.1.1 (c) (i)) | 1 |
Nearside Front Inner Vehicle structure strengthening plate or fastening so insecure that structural rigidity is seriously reduced wheel arch (6.1.1 (b) (ii)) | 1 |
Offside Front Vehicle structure strengthening plate or fastening so insecure that structural rigidity is seriously reduced wheel arch (6.1.1 (b) (ii)) | 1 |
Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i)) | 1 |
Rear Service brake excessively binding Both the brake binding (1.2.1 (f)) | 1 |
Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i)) | 1 |
Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i)) | 1 |
Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i)) | 1 |
Windscreen wiper not working (3.4 (a)) | 1 |
Headlamp aim projected beam image is obviously incorrect both sides (4.1.2 (c)) | 1 |
Rear Service brake lagging in operation (1.2.1 (d)) | 1 |
Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i)) | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Horn not working (7.7 (a) (ii)) | 1 |
Fuel system component leaking fuel leak off pip leaking (6.1.3 (b) (i)) | 1 |
Battery insecure and likely to fall from carrier (4.13 (a) (ii)) | 1 |
Offside Rear Direction indicator not working |1.4.A.2c| | 1 |
Nearside Parking brake inoperative on one side (1.4.1 (a)) | 1 |
Nearside Windscreen wiper blade deteriorated |8.2.2| | 1 |
Offside Windscreen wiper blade deteriorated |8.2.2| | 1 |
Horn not working |7.7 |a| |ii|| | 1 |
Front brake application uneven | 1 |
Nearside front parking |secondary| brake grabbing severely |3.7.B.6b| | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Rear Rear fog lamp not working stop light and fog light are the same light (4.5.1 (a) (ii)) | 1 |
Headlamp aim projected beam image is obviously incorrect both front lamps (4.1.2 (c)) | 1 |
Front Position lamp not working both inop (4.2.1 (a) (ii)) | 1 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 1 |
Rear parking brake recording little or no effort | 1 |
Offside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i)) | 1 |
Nearside Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i)) | 1 |
Rear Brake valve leaking |3.6.A.1| | 1 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |