Most common failures | No# failures |
---|
Exhaust emissions hydrocarbon content excessive (8.2.1.2 (b)) | 2 |
Windscreen washer not working | 2 |
Brakes imbalanced across an axle | 2 |
Oil leaking excessively from engine (8.4.1 (a) (i)) | 1 |
Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement |7.2.4b| | 1 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Rear Direction indicator incorrect colour |1.4.A.2f| | 1 |
Stop lamp emits other than a steady red light |1.2.1e| | 1 |
Nearside Rear Leaf spring fractured |2.4.B.1a| | 1 |
Offside Rear Leaf spring deteriorated and seriously weakened |2.4.B.1a| | 1 |
Brake load sensing valve linkage seized |3.6.E.3| | 1 |
Nearside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Exhaust emissions carbon monoxide content at idle excessive |7.3.D.4| | 1 |
Exhaust emissions hydrocarbon content after 2nd fast idle excessive |7.3.D.3| | 1 |
Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3| | 1 |
Exhaust emissions hydrocarbon content excessive |8.2.1.2 |b|| | 1 |
Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength Jacking point area |5.3.6 |a| |i|| | 1 |
Nearside Front Shock absorbers has a serious fluid leak | 1 |
Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength Inner sill area |5.3.6 |a| |i|| | 1 |
Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength Next to spring hanger |5.3.6 |a| |i|| | 1 |
Nearside Rear Service brake effort inadequate at a wheel |1.2.1 |a| |i|| | 1 |
Offside Rear Service brake effort inadequate at a wheel |1.2.1 |a| |i|| | 1 |
Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced Inner sill/floor |7.1.1 |a| |i|| | 1 |
Service brake efficiency below requirements |1.2.2 |a| |i|| | 1 |
Offside Rear position lamp|s| incorrect colour |1.1.A.3e| | 1 |
Offside Rear fog lamp does not emit a steady red light |1.3.2e| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Windscreen wiper not working (3.4 (a)) | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Registration plate lamp issues | 1 |
Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Nearside Rear Position lamp not working |4.2.1 |a|| | 1 |
Nearside Rear Stop lamp|s| adversely affected by the operation of another lamp |4.3.3 |b|| | 1 |
Exhaust hydrocarbon content after 2nd fast idle exceeds default limits |8.2.1.2 |b|| | 1 |
Nearside Rear Suspension spring mounting prescribed area is inadequately repaired |5.3.6 |a| |i|| | 1 |
Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength cross member |5.3.6 |a| |i|| | 1 |
Offside Front Subframe mounting prescribed area is inadequately repaired |5.3.6 |a| |i|| | 1 |
Nearside Front Seat belt anchorage prescribed area is inadequately repaired |7.1.1 |a| |i|| | 1 |
Rear Brake load sensing valve seized but ABS functioning (1.1.17 (c) (i)) | 1 |
Central Exhaust system insecure (6.1.2 (a)) | 1 |
Nearside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 1 |
Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
Emissions not tested (8.2.1.2 (d)) | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |
Rear brake application uneven | 1 |
Rear parking brake recording little or no effort | 1 |
Offside Rear position lamp|s| incorrect colour Damaged showing white light |1.1.A.3e| | 1 |
Offside Rear fog lamp does not emit a steady red light Damaged showing white light |1.3.2e| | 1 |
Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Centre Upper Stop lamp not working |1.2.1b| | 1 |