Most common failures | No# failures |
---|
Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c)) | 4 |
Registration plate lamp issues | 3 |
Windscreen wiper does not clear the windscreen effectively | 3 |
Offside Front Position lamp not working (4.2.1 (a) (ii)) | 2 |
Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 2 |
Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 2 |
Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b)) | 2 |
Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
Nearside Rear Brake disc contaminated (1.1.14 (b)) | 1 |
Offside Rear Service brake excessively binding (1.2.1 (f)) | 1 |
Exhaust carbon monoxide content at idle exceeds manufacturers specified limits (8.2.1.2 (b)) | 1 |
Offside Rear Brake disc contaminated rust (1.1.14 (b)) | 1 |
Offside Rear Rear fog lamp does not emit a steady red light (4.5.4 (a)) | 1 |
Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
Emissions not tested (8.2.1.2 (d)) | 1 |
Nearside Front Brake disc significantly and obviously worn (1.1.14 (a) (i)) | 1 |
Offside Front Brake disc significantly and obviously worn (1.1.14 (a) (i)) | 1 |
Nearside Front Suspension arm pin or bush excessively worn front bush (5.3.4 (a) (i)) | 1 |
Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Nearside Front Direction indicators not working |1.4.A.2c| | 1 |
Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Rear fog lamp does not emit a steady red light (4.5.4 (a)) | 1 |
Brake pipe excessively corroded | 1 |
Headlamp aim projected beam image is obviously incorrect both front (4.1.2 (c)) | 1 |
Seat belt not functioning as intended centre lap jammed (7.1.2 (c)) | 1 |
Nearside Rear Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sil (6.2.2 (d) (i)) | 1 |
Road wheel more than one fixing missing (5.2.1 (a) (ii)) | 1 |
Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a)) | 1 |
Exhaust has a major leak of exhaust gases middle box back box corroded (6.1.2 (a)) | 1 |
Offside Front Body panel corroded and likely to cause injury wing (6.2.1 (a) (i)) | 1 |
Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i)) | 1 |
Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i)) | 1 |
Offside Front Suspension component pin or bush likely to become detached DO NOT DRIVE!! (5.3.4 (a) (ii)) | 1 |
Nearside Front Suspension component ball joint excessively worn (5.3.4 (a) (i)) | 1 |
Central Rear Anti-roll bar pin or bush excessively worn both d bushes (5.3.4 (a) (i)) | 1 |
Rear Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Central Front Exhaust system insecure (6.1.2 (a)) | 1 |
Stop lamp(s) switch with a delay in operation (4.3.2 (a) (ii)) | 1 |
Central Stop lamp(s) with a multiple light source more than 1/2 not functioning (4.3.1 (a) (ii)) | 1 |
Offside Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt inner (6.1.7 (g) (ii)) | 1 |
Rear fog lamp missing (4.5.1 (a) (ii)) | 1 |