Most common failures | No# failures |
---|
Windscreen wiper does not clear the windscreen effectively | 7 |
Headlamp aim out of alignment | 4 |
Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a)) | 3 |
Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 3 |
Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 2 |
Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 2 |
Offside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 2 |
Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i)) | 2 |
Nearside Front Road wheel fixing missing (5.2.1 (a) (i)) | 1 |
Offside Front Road wheel fixing missing (5.2.1 (a) (i)) | 1 |
Nearside Front Lower Suspension component ball joint excessively worn (5.3.4 (a) (i)) | 1 |
Offside Front Lower Suspension component ball joint excessively worn (5.3.4 (a) (i)) | 1 |
Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h)) | 1 |
Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b)) | 1 |
Drivers airbag obviously inoperative (7.1.5 (c)) | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Nearside Rear Service brake grabbing severely (1.2.1 (c)) | 1 |
Offside Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
Offside Headlamp insecure (4.1.1 (c)) | 1 |
Nearside Headlamp aim not tested (4.1.2 (b)) | 1 |
Offside Rear fog lamp not working |1.3.2b| | 1 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Front Torque/reaction arm has a deteriorated rubber bush resulting in excessive movement |2.4.G.2| | 1 |
Offside Front Torque/reaction arm has a deteriorated rubber bush resulting in excessive movement |2.4.G.2| | 1 |
Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Offside Rear Position lamp with a multiple light source more than 1/2 not functioning (4.2.1 (a) (ii)) | 1 |
Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 1 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i)) | 1 |
Offside Front Lower Suspension arm pin or bush likely to become detached wishbone rear mount. (5.3.4 (a) (ii)) | 1 |
Nearside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
Nearside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i)) | 1 |
Nearside Rear Parking brake inoperative on one side (1.4.1 (a)) | 1 |
Nearside Track rod end ball joint has excessive play (2.1.3 (b) (i)) | 1 |
Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Offside Rear Seat belt retracting mechanism defective (7.1.2 (e)) | 1 |
Nearside Front Lower Suspension arm ball joint excessively worn |5.3.4 |a| |i|| | 1 |
Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 1 |
Front brake application uneven | 1 |
Offside Rear Coil spring fractured or broken (5.3.1 (b) (i)) | 1 |
Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
Exhaust emissions likely to be affected by an exhaust leak lambda too high (8.2.1.1 (b)) | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill area (5.3.6 (a) (i)) | 1 |
Nearside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
Anti-lock braking system warning lamp indicates an ABS fault | 1 |
Drivers door cannot be opened from inside the vehicle (6.2.3 (a)) | 1 |
Offside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |