Most common failures | No# failures |
---|
Headlamp aim out of alignment | 3 |
Windscreen washer not working | 2 |
Offside Front Service brake excessively binding (1.2.1 (f)) | 1 |
Brakes imbalanced across an axle | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength |5.3.6 |a| |i|| | 1 |
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength |5.3.6 |a| |i|| | 1 |
Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength |5.3.6 |a| |i|| | 1 |
Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced |7.1.1 |a| |i|| | 1 |
Nearside Front Lower Suspension rod attachment bracket/mounting insecure and impairing directional stability |5.3.3 |a| |ii|| | 1 |
Brake pedal anti-slip provision missing |3.3.A.1b| | 1 |
Nearside Front Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Windscreen wiper does not clear the windscreen effectively | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Vehicle Identification Number not permanently displayed |6.3.5.a| | 1 |
Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Corrosion to torsion bar mounting point (5.3.6 (a) (i)) | 1 |
Nearside Rear Shock absorbers insecurely attached Locking device missing from bottom mount (5.3.2 (a) (i)) | 1 |
Offside Rear Shock absorbers likely to become detached Locking device missing from bottom mount (5.3.2 (a) (ii)) | 1 |
Nearside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
Offside Front Suspension component mounting prescribed area is inadequately repaired Chassis rail repair inadequate (5.3.6 (a) (i)) | 1 |
Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) | 1 |
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Fuel pipe insecure on fuel pump close to exhaust |7.2.1| | 1 |
Brake performance not tested all brakes binding |3.7.A.1| | 1 |
Bonnet retaining device ineffective |8.4.2| | 1 |