Most common failures | No# failures |
---|
Brake pipe excessively corroded | 8 |
Registration plate lamp issues | 6 |
Windscreen wiper does not clear the windscreen effectively | 6 |
Horn not working |1.6.2a| | 3 |
Front Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 2 |
Parking brake: efficiency below requirements |3.7.B.7| | 2 |
Offside Stop lamp not working |1.2.1b| | 2 |
Brake pedal creeps down when held under pressure |3.3.B.1a| | 1 |
Nearside Front Lower Shock absorber has an excessively worn bush |2.7.4| | 1 |
Offside Front Lower Shock absorber has an excessively worn bush |2.7.4| | 1 |
Centre Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Nearside Front Steering pivot point has excessive play |2.2.B.1g| | 1 |
Offside Front Anti-roll bar has excessive play in a ball joint |2.4.G.2| | 1 |
Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Offside Front Wheel nut|s| missing |4.2.A.1e| | 1 |
Nearside Rear Rear position lamp|s| not working |1.1.A.3b| | 1 |
Direction indicators not working |1.4.A.2c| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Rear Stop lamp adversely affected by the operation of another lamp |1.2.1f| | 1 |
Nearside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
rear brake recording little or no effort |3.7.B.5a| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Offside Front Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Centre Rear Seat belt has a cut which has significantly weakened the webbing |5.2.2a| | 1 |
Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |