>

MOT History from tests of petrol MITSUBISHI EVOs year 2007

Review the list of common MITSUBISHI EVO failures below or to perform a specific mot history check on your MITSUBISHI then use our popular KnowYourCar service

mot history
Pass percent:87.57%
(The average a petrol MITSUBISHI EVO year 2007 passes without issue)
Based on:177 MOT Tests
Most common failuresNo# failures
Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3|4
Windscreen wiper does not clear the windscreen effectively3
Headlamp aim out of alignment2
Nearside Front position lamp|s| not working |1.1.A.3b|2
Brake pipe excessively corroded2
Offside Front position lamp|s| not working |1.1.A.3b|1
Nearside Front Steering locking device missing |2.2.C.1g|1
Windscreen has damage1
Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3|1
Offside Rear Suspension spring mounting prescribed area is excessively corroded chassie leg |2.4.A.3|1
Nearside Front Suspension component mounting prescribed area is excessively corroded crossmember |2.4.A.3|1
Offside Front Suspension component mounting prescribed area is excessively corroded crossmember |2.4.A.3|1
Nearside Front Headlamp not in good working order adversely affecting beam image |1.2.4a|1
Offside Front Headlamp not in good working order adversely affecting beam image |1.2.4a|1
Nearside Rear Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2|1
Offside Rear Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2|1
Front Rear fog lamp not working |4.5.1 |a| |ii||1
Anti-lock braking system warning lamp indicates an ABS fault1
Offside Rear fog lamp not working |1.3.2b|1
Rear Exhaust has a major leak of exhaust gases |7.1.2|1
Offside Front Position lamp not working |4.2.1 |a||1
Nearside Rear Rear wheel bearing has excessive play |2.6.2|1
Offside Rear Rear wheel bearing has excessive play |2.6.2|1
Nearside Front Position lamp not working (4.2.1 (a) (ii))1
Offside Front Position lamp not working (4.2.1 (a) (ii))1
Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a))1
Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))1
Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a))1
Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))1
Emissions not tested (8.2.1.2 (d))1
Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))1
Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))1
Nearside Headlamp light source and lamp not compatible (4.1.4 (c))1
Offside Headlamp light source and lamp not compatible (4.1.4 (c))1
Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))1
Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))1
Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))1
Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))1
Exhaust catalytic converter missing where one was fitted as standard (8.2.2.1 (a))1
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))1
Offside Outer Direction indicator incorrect colour (4.4.3 (a))1
Exhaust emissions hydrocarbon content after 2nd fast idle excessive |7.3.D.3|1
Nearside Rear Position lamp not working (4.2.1 (a) (ii))1
Battery insecure and likely to fall from carrier (4.13 (a) (ii))1
Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer chassis (5.3.6 (a) (i))1
Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))1
Offside Front Position lamp light intensity significantly reduced (4.2.3 (a) (ii))1
Brake performance unable to be tested (1.2.1 (g))1
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))1
Nearside Outer Direction indicator incorrect colour (4.4.3 (a))1
Registration plate issues1
Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))1
Offside Rear Position lamp not working (4.2.1 (a) (ii))1
Nearside Front Position lamp light intensity significantly reduced (4.2.3 (a) (ii))1
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))1
Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced front floor. Door sill. Rear inner arch (6.1.1 (c) (i))1

We get to these numbers by trawling through over 1 billion MOT test results since 2004 and crunched the numbers. We remove anything to do with Tyres, as they are model independent and group together common non-model specific issues. We are trying to get to a picture of what models have what issues.

Please note: We take the data from the DVSA. This data is raw and can contain typos and spelling mistakes that garages may have entered while recording a MOT result. Specifically miss-match on names of models and makes. We are constantly cleaning the data so bear with the odd issue.

Got suggestions? We’re improving this section all the time. If you have any suggestions, please let us know.

Find us on Facebook

© KnowYourCar™ 2019. All rights reserved
Except where otherwise noted, content on our MOT statistics pages are licensed under a Creative Commons Attribution 4.0 International license.
You are free to redistribute the material in any medium or format as long as credit is given to KnowYourCar

WARNING: We have placed hidden watermarks in our data. We will take action against our data being used outside of these terms.

MOT Data licensed under the Open Government Licence v3.0

By using our site you are agreeing to our terms and conditions
Terms & Conditions  Privacy Policy