Most common failures | No# failures |
---|
Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 23 |
Brake pipe excessively corroded | 17 |
Windscreen wiper does not clear the windscreen effectively | 13 |
Registration plate lamp issues | 12 |
Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3| | 12 |
Exhaust emissions carbon monoxide content at idle excessive |7.3.D.4| | 10 |
Headlamp aim out of alignment | 9 |
Rear fog lamp not working |1.3.2b| | 5 |
Horn not working |1.6.2a| | 4 |
Registration plate issues | 4 |
Anti-lock braking system warning lamp indicates an ABS fault | 4 |
Exhaust emissions hydrocarbon content after 2nd fast idle excessive |7.3.D.3| | 4 |
Offside Headlamp not working on dipped beam |1.7.5a| | 4 |
Parking brake lever has no reserve travel |3.1.6b| | 3 |
Offside Rear fog lamp not working |1.3.2b| | 3 |
Offside Rear fog lamp missing |1.3.2a| | 3 |
Rear fog lamp tell tale not working |1.3.1b| | 2 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 2 |
Rear Rear fog lamp missing |1.3.2a| | 2 |
Offside Rear fog lamp emits a light other than red |1.3.2e| | 2 |
Brake hose has insufficient room to move | 2 |
Nearside Front Front position lamp|s| not working |1.1.A.3b| | 2 |
Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Emissions not tested |7.0| | 2 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 2 |
Exhaust catalytic converter missing where one was fitted as standard |7.1.3| | 2 |
Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c)) | 2 |
Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b)) | 2 |
Electrical wiring insecure (1.9.2a) | 2 |
Offside Steering rack gaiter split (2.2.D.2d) | 2 |
Offside Front Position lamp not working (4.2.1 (a) (ii)) | 2 |
Nearside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Offside Rear fog lamp tell tale not working |1.3.1b| | 1 |
Rear fog lamp switch faulty |1.3.1a| | 1 |
Nearside Front Side repeater incorrect colour |1.4.A.2f| | 1 |
Offside Rear Rear fog lamp missing |1.3.2a| | 1 |
Front position lamp|s| not working Both |1.1.A.3b| | 1 |
Headlamp aim beam image obviously incorrect Both sides bulbs incorrectly fitted |1.8.A.1b| | 1 |
Offside Rear Upper Anti-roll bar linkage has excessive play in a ball joint Nut loose |2.4.G.2| | 1 |
Nearside Front Steering rack gaiter split |2.2.D.2d| | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch |5.3.6 |a| |i|| | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer`s specified limits |8.2.1.2 |a|| | 1 |
Nearside Steering rack gaiter split |2.2.D.2d| | 1 |
Nearside Headlamp aim aimed so that it dazzles other road users |1.8.A.1a| | 1 |
Nearside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Nearside Rear Stop lamp not working |1.2.1b| | 1 |
Nearside Headlamp incorrect colour |1.7.5b| | 1 |
Offside Headlamp incorrect colour |1.7.5b| | 1 |
Centre Exhaust mounting missing |7.1.1b| | 1 |
Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Rear fog lamp emits a light other than red |1.3.2e| | 1 |
Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Nearside Front Front wheel bearing has excessive play |2.5.A.3c| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Brakes imbalanced across an axle | 1 |
Front brake disc in such a condition that it is seriously weakened | 1 |
Nearside Headlamp not working on dipped beam |4.1.1 |a| |ii|| | 1 |
Offside Headlamp not working on dipped beam |4.1.1 |a| |ii|| | 1 |
Front Lower Trailing arm has excessive play in a ball joint |2.4.G.2| | 1 |
Brake pedal anti-slip provision missing |3.3.A.1b| | 1 |
Offside Rear Seat belt has a cut which has significantly weakened the webbing |5.2.2a| | 1 |
Offside Front Steering column universal joint has excessive play |2.1.5| | 1 |
Nearside Rear Lower Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Offside Rear Lower Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Centre Rear Fuel pipe insecure |7.2.1| | 1 |
Rear fog lamp not working |4.5.1 |a| |ii|| | 1 |
Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floorpan |5.3.6 |a| |i|| | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis |5.3.6 |a| |i|| | 1 |
Front Windscreen wiper not operating automatically when switched on |8.2.1b| | 1 |
Offside Front Seat belt anchorage prescribed area is excessively corroded inner sill |5.2.6| | 1 |
Nearside Front Seat belt insecurely fixed to the vehicles structure |5.2.1a| | 1 |
Offside Front Seat belt insecurely fixed to the vehicles structure |5.2.1a| | 1 |
Nearside Rear Shock absorber has a serious fluid leak |2.7.3| | 1 |
Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
Offside Front Braking system leaking |3.6.A.1| | 1 |
Offside Front constant velocity joint is excessively worn |2.5.C.1b| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded outter sill |2.4.A.3| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded outter sill |2.4.A.3| | 1 |
Rear Fuel tank leaking |7.2.3| | 1 |
Front Exhaust has a part missing |7.1.1a| | 1 |
Driver`s seat insecure |6.2.A.1| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded floor |2.4.A.3| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded floor |2.4.A.3| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded chassis |2.4.A.3| | 1 |
Nearside Rear Inner Suspension component mounting prescribed area is excessively corroded arch |2.4.A.3| | 1 |
Offside Rear Inner Suspension component mounting prescribed area is excessively corroded arch |2.4.A.3| | 1 |
Nearside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside Rear Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Emissions not tested |8.2.1.2 |d|| | 1 |
Exhaust catalytic converter missing where one was fitted as standard |8.2.2.1 |a|| | 1 |
Offside Rear fog lamp not working new bulb |1.3.2b| | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer + inner sill (5.3.6 (a) (i)) | 1 |
Nearside Front Direction indicator not working (4.4.1 (a) (ii)) | 1 |
Rear fog lamp does not emit a steady red light (4.5.4 (a)) | 1 |
Offside Headlamp not working on dipped beam (1.7.5a) | 1 |
Nearside Rear Lower Suspension arm has excessive play in a ball joint (2.4.G.2) | 1 |
Offside Rear Lower Suspension arm has excessive play in a pin/bush outer hub (2.4.G.2) | 1 |
Electrical wiring deteriorated and bare wires exposed (1.9.2c) | 1 |
Electrical wiring inadequately supported (1.9.2a) | 1 |
Offside Stop lamp not working (1.2.1b) | 1 |
Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4) | 1 |
Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3) | 1 |
Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3) | 1 |
Exhaust catalytic converter missing where one was fitted as standard (7.1.3) | 1 |
Hazard warning lamps inoperative (1.4.B.1b) | 1 |
Offside Rear fog lamp not working (1.3.2b) | 1 |
Nearside Rear Suspension arm has excessive play in a pin/bush (2.4.G.2) | 1 |
Offside Rear Suspension arm has excessive play in a pin/bush (2.4.G.2) | 1 |
Offside Front Electrical wiring insecure (1.9.2a) | 1 |
Nearside Electrical wiring insecure (1.9.2a) | 1 |
Nearside Front Suspension arm has excessive play in a pin/bush (2.4.G.2) | 1 |
Rear fog lamp not working (1.3.2b) | 1 |
Nearside Headlamp adversely affected by the operation of another lamp (1.7.5c) | 1 |
Nearside Headlamp aim aimed so that it dazzles other road users (1.8.A.1a) | 1 |
Nearside Steering rack gaiter split (2.2.D.2d) | 1 |
Offside Rear Seat belt buckle not functioning as intended (7.1.2 (d)) | 1 |
Exhaust carbon monoxide content at idle exceeds manufacturers specified limits (8.2.1.2 (b)) | 1 |
Nearside Front Lower Suspension component ball joint excessively worn (5.3.4 (a) (i)) | 1 |
Offside Front Lower Suspension component ball joint excessively worn (5.3.4 (a) (i)) | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing area. (5.3.6 (a) (i)) | 1 |
Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b)) | 1 |