Most common failures | No# failures |
---|
Service brake: efficiency below requirements |3.7.B.7| | 5 |
Registration plate lamp issues | 4 |
Parking brake: efficiency below requirements |3.7.B.7| | 4 |
Headlamp aim out of alignment | 4 |
Brakes imbalanced across an axle | 4 |
Horn not working |1.6.2a| | 2 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 2 |
Offside Front position lamp|s| not working |1.1.A.3b| | 2 |
Offside Outer Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Outer Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Front Braking system leaking |3.6.A.1| | 1 |
Brake pedal has insufficient reserve movement |3.3.A.5| | 1 |
Offside Rear Wheel nut|s| missing |4.2.A.1e| | 1 |
Nearside Rear Coil spring not correctly located |2.4.C.2| | 1 |
Offside Steering rack gaiter split |2.2.D.2d| | 1 |
Nearside Rear Brake pivot has restricted free movement |3.5.1k| | 1 |
Offside Obligatory mirror seriously damaged, affecting the rear view |8.1.2a| | 1 |
Offside Front Ball joint has excessive play |2.2.B.1f| | 1 |
Offside rear brake recording little or no effort |3.7.B.5a| | 1 |
Offside Direction indicator flashing less than 60 times a minute |1.4.A.2g| | 1 |
Nearside Front Front wheel bearing has excessive play |2.5.A.3c| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded boot floor |2.4.A.3| | 1 |
Nearside Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Inner Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Rear brake binding | 1 |
Offside Rear Lower Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Bonded suspension unit deteriorated and cannot function as intended |2.4.F.3| | 1 |
Nearside Rear Rear wheel bearing has excessive play |2.6.2| | 1 |
Front Headlamp not working on main beam |1.7.5a| | 1 |
Nearside Rear Direction indicator not working |1.4.A.2c| | 1 |
Nearside Rear Direction indicator adversely affected by the operation of another lamp |1.4.A.2h| | 1 |
Driver`s seat insecure |6.2.A.1| | 1 |
Nearside Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
Offside Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
Offside Obligatory mirror missing |8.1.1| | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition |7.1.4| | 1 |
Nearside Headlamp excessively damaged so that the light output is severely reduced |1.7.5a| | 1 |
Offside Headlamp excessively damaged so that the light output is severely reduced |1.7.5a| | 1 |
Centre Exhaust system not adequately supported |7.1.1| | 1 |
Offside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Hazard warning switch faulty |1.4.B.1d| | 1 |
Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Nearside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |