Most common failures | No# failures |
---|
Headlamp aim out of alignment | 3 |
Parking brake: efficiency below requirements |3.7.B.7| | 2 |
Nearside Front brake caliper securing device loose |3.5.1j| | 1 |
Offside Front brake caliper securing device loose |3.5.1j| | 1 |
Nearside Front brake caliper leaking |3.6.A.1| | 1 |
Exhaust engine idle speed too high |7.3.A.2a| | 1 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 1 |
Exhaust emissions hydrocarbon content excessive |7.3.B.1b| | 1 |
Offside Steering locking device insecure track rod end to track rod nut |2.2.C.1g| | 1 |
Nearside Front Seat belt retracting mechanism defective |5.2.5b| | 1 |
Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone `A` |8.3.1b| | 1 |
Brake performance not tested |3.7.A.1| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Rear parking brake recording little or no effort | 1 |
Parking brake lever has no reserve travel |3.1.6b| | 1 |
Direction indicators flashing less than 60 times a minute |1.4.A.2g| | 1 |
Emissions not tested |7.3.A.1| | 1 |
Offside Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i)) | 1 |
Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i)) | 1 |
Offside Floor excessively deteriorated (6.2.4 (a) (i)) | 1 |
Nearside Engine mounting bracket excessively loose (6.1.8 (a) (ii)) | 1 |
Rear Prop shaft securing bolt missing (6.1.7 (a) (i)) | 1 |
Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a)) | 1 |
Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c)) | 1 |
Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a)) | 1 |
Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) | 1 |
Brakes imbalanced across an axle | 1 |