Most common failures | No# failures |
---|
Headlamp aim out of alignment | 4 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Offside Front position lamp(s) not working (1.1.A.3b) | 2 |
Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3) | 1 |
Offside Rear Suspension component mounting prescribed area is fractured (2.4.A.3) | 1 |
Offside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Windscreen wiper does not clear the windscreen effectively | 1 |
Exhaust emits dense blue smoke at idle (7.3.A.2b) | 1 |
Exhaust emits excessive dense blue smoke during acceleration (7.3.A.2c) | 1 |
Horn not working |1.6.2a| | 1 |
Brake pedal creeps down when held under pressure |3.3.B.1a| | 1 |
Offside Front brake caliper leaking |3.6.A.1| | 1 |
Offside Rear brake caliper leaking |3.6.A.1| | 1 |
Brake performance not tested |3.7.A.1| | 1 |
Fuel hose leaking |7.2.3| | 1 |
Offside Rear Vehicle structure has an inadequate repair which adversely affects braking or steering |6.1.A.1| | 1 |
Nearside Front Vehicle structure has an inadequate repair which adversely affects braking or steering |6.1.A.1| | 1 |
Offside Front Vehicle structure has an inadequate repair which adversely affects braking or steering |6.1.A.1| | 1 |
Rear Mechanical brake component has restricted free movement | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |
Indicator switch faulty |1.4.A.1| | 1 |
Offside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f) | 1 |
Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f) | 1 |
Indicator switch faulty (1.4.A.1) | 1 |
Rear position lamp|s| excessively damaged so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Nearside Rear Brake hose bulging under pressure (3.6.B.3) | 1 |
Offside Track rod end ball joint has excessive play (2.2.B.1f) | 1 |
Exhaust emits excessive dense blue smoke during acceleration (8.2.1.2 (g)) | 1 |
Nearside Front Lower Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i)) | 1 |
Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i)) | 1 |
Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i)) | 1 |
Emissions not tested |7.0| | 1 |
Front Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings jack point inner and outher (6.1.B.2) | 1 |
Offside Front Seat belt retracting mechanism defective (5.2.5b) | 1 |
Registration plate lamp issues | 1 |
Offside Rear Rear fog lamp not working (1.3.2b) | 1 |
Offside Rear Headlamp not working on dipped beam (1.7.5a) | 1 |