Most common failures | No# failures |
---|
Headlamp aim out of alignment | 3 |
Brake pipe excessively corroded | 2 |
Service brake efficiency below requirements (1.2.2 (a) (i)) | 2 |
Offside Stop lamp not working |1.2.1b| | 1 |
Brake load sensing valve linkage seized |3.6.E.3| | 1 |
Brake master cylinder/servo mounting prescribed area is excessively corroded brake servo mounting |1.1.21 |e| |i|| | 1 |
Offside Front Service brake excessively binding |1.2.1 |f|| | 1 |
Offside Service brake has no recorded effort at a wheel |1.2.1 |a| |ii|| | 1 |
Offside Rear Parking brake inoperative on one side |1.4.1 |a|| | 1 |
Service brake efficiency below requirements |1.2.2 |a| |i|| | 1 |
Parking brake efficiency below requirements |1.4.2 |a| |i|| | 1 |
Offside Rear Direction indicators not working |1.4.A.2c| | 1 |
Offside Rear Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
Registration plate lamp issues | 1 |
Brake hose excessively deteriorated | 1 |
Parking brake: efficiency below requirements |3.7.C.1b| | 1 |
Rear parking brake recording little or no effort | 1 |
Braking system leaking |3.6.A.1| | 1 |
Nearside Rear Stop lamp not working |1.2.1b| | 1 |
Offside Rear Stop lamp not working |1.2.1b| | 1 |
Offside Front Service brake excessively binding (1.2.1 (f)) | 1 |
Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Brake servo defective or ineffective vac leak from servo unit (1.1.10 (a) (i)) | 1 |
Nearside Front Brake pipe likely to become detached or damaged steel pipe chaffeing body work (1.1.11 (d) (ii)) | 1 |
Offside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
Offside Rear Parking brake inoperative on one side low effort recorded (1.4.1 (a)) | 1 |
Central Front Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a)) | 1 |
Front Windscreen wiper not working (3.4 (a)) | 1 |
Central Front Bonnet primary retaining device ineffective (3.1 (c)) | 1 |
Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
Offside Lower Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
Bonnet primary retaining device excessively deteriorated (3.1 (c)) | 1 |
Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced near front leaf spring bush. (nsf wheel arch) (6.1.1 (c) (i)) | 1 |
Nearside Front Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
Offside Front Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
Offside Front Drag link end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |