Most common failures | No# failures |
---|
Offside Rear fog lamp not working |1.3.2b| | 5 |
Exhaust has a major leak of exhaust gases |7.1.2| | 4 |
Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 2 |
Brakes imbalanced across an axle | 2 |
Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 2 |
Offside Front Service brake excessively binding |1.2.1 |f|| | 1 |
Nearside Front Suspension spring mounting prescribed area is excessively corroded chassis leg |2.4.A.3| | 1 |
Front Suspension spring mounting prescribed area is excessively corroded cross beam on both sides |2.4.A.3| | 1 |
Nearside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Headlamp aim out of alignment | 1 |
Nearside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Drag link end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Offside Steering component mounting prescribed area is excessively corroded |2.2.C.1h| | 1 |
Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Front brake application uneven | 1 |
Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Offside Rear Body has a sharp edge caused by damage |6.1.C.1| | 1 |
Nearside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Offside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Exhaust emits an excessive level of metered smoke for a non-turbo charged engine |7.4.B.3b| | 1 |
Offside Rear fog lamp not working |4.5.1 |a| |ii|| | 1 |
Brake pedal creeps down when held under pressure |3.3.B.1a| | 1 |
Brake load sensing valve linkage seized |3.6.E.3| | 1 |
Rear brake application uneven | 1 |
Brake hose excessively deteriorated | 1 |
Nearside Front Brake pipe inadequately clipped |3.6.B.1| | 1 |
Nearside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Brake performance not tested |3.7.A.1| | 1 |
Service brake: efficiency below requirements |3.7.C.1a| | 1 |
Parking brake: efficiency below requirements |3.7.C.1b| | 1 |