| Most common failures | No# failures |
|---|
| Brake pipe excessively corroded | 8 |
| Service brake: efficiency below requirements |3.7.B.7| | 4 |
| Brake hose excessively deteriorated | 3 |
| Windscreen wiper does not clear the windscreen effectively | 3 |
| Registration plate lamp issues | 2 |
| Brakes imbalanced across an axle | 2 |
| Nearside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
| Nearside Front Lower Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2| | 1 |
| Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Front Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
| Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Rear Vehicle structure has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Front Vehicle structure has a modification which adversely affects braking or steering |6.1.A.1| | 1 |
| Exhaust emits an excessive level of metered smoke for a non-turbo charged engine |7.4.B.3b| | 1 |
| Rear Mechanical brake component has restricted free movement | 1 |
| Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Driver`s seat insecure |6.2.A.1| | 1 |
| Brake load sensing valve seized |3.6.E.3| | 1 |
| Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
| Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Front Direction indicator not working |1.4.A.2c| | 1 |
| Front Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 1 |
| Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
| Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Nearside Headlamp aim not tested |1.8.A.1c| | 1 |
| Rear fog lamp switch faulty |1.3.1a| | 1 |
| Nearside Rear fog lamp not working |1.3.2b| | 1 |
| Offside Rear reflector not red in colour |1.5.1d| | 1 |
| Offside Stop lamp emits other than a steady red light |1.2.1e| | 1 |
| Rear Exhaust system not adequately supported |7.1.1| | 1 |
| Parking brake: efficiency below requirements |3.7.B.7| | 1 |
| Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength |5.3.6 |a| |i|| | 1 |
| Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced |7.1.1 |a| |i|| | 1 |
| Offside Seat belt anchorage prescribed area strength or continuity significantly reduced |7.1.1 |a| |i|| | 1 |
| Nearside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
| Exhaust has a major leak of exhaust gases |6.1.2 |a|| | 1 |
| Anti-roll bar rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Nearside Stop lamp not working |1.2.1b| | 1 |
| Offside Stop lamp not working |1.2.1b| | 1 |
| Offside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
| Nearside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill as marked (6.2.2 (d) (i)) | 1 |
| Offside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill as marked (6.2.2 (d) (i)) | 1 |