| Most common failures | No# failures |
|---|
| Nearside Front Lower Suspension arm has excessive play in a ball joint |2.4.G.2| | 2 |
| Registration plate lamp issues | 2 |
| Nearside Front Suspension arm has excessive play in a ball joint |2.4.G.2| | 2 |
| Brake hose excessively deteriorated | 2 |
| Brake pipe excessively corroded | 1 |
| Brake load sensing valve linkage seized |3.6.E.3| | 1 |
| Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Emissions not tested |7.0| | 1 |
| Brake load sensing valve linkage defective and function impaired |3.6.E.3| | 1 |
| Offside Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Offside Front Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
| Nearside Front Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Offside Rear fog lamp not working |1.3.2b| | 1 |
| Offside Front Lower Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
| Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
| Nearside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Offside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Headlamp aim out of alignment | 1 |
| Offside Front Headlamp aim projected beam image is obviously incorrect |4.1.2 |c|| | 1 |
| Nearside Front Seat belt has a cut which has significantly weakened the webbing |5.2.2a| | 1 |
| Nearside Rear Brake load sensing valve seized but ABS functioning |1.1.17 |c| |i|| | 1 |
| Offside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill |7.1.1 |a| |i|| | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill |5.3.6 |a| |i|| | 1 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
| Emissions not tested (8.2.2.2 (e)) | 1 |
| Horn not working (7.7 (a)) | 1 |
| Rear Service brake effort inadequate at a wheel both (1.2.1 (a) (i)) | 1 |
| Rear Suspension component mounting prescribed area is inadequately repaired both upper shock absorber mounting areas outer chassis (5.3.6 (a) (i)) | 1 |
| Suspension component mounting prescribed area excessively corroded significantly reducing structural strength both rear chassis legs by brake hose mounting areas (5.3.6 (a) (i)) | 1 |
| Anti-roll bar pin or bush excessively worn both rear "D" bushes (5.3.4 (a) (i)) | 1 |
| Nearside Front Anti-roll bar pin or bush excessively worn "D" bush (5.3.4 (a) (i)) | 1 |
| Horn not working |1.6.2a| | 1 |
| Nearside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
| Offside Front position lamp|s| not working |1.1.A.3b| | 1 |