| Most common failures | No# failures |
|---|
| Centre Exhaust system not adequately supported |7.1.1| | 2 |
| Registration plate lamp issues | 2 |
| Front Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
| Nearside Rear Direction indicator not working |1.4.A.2c| | 2 |
| Centre Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
| Offside Rear Direction indicator not working |1.4.A.2c| | 2 |
| Windscreen wiper does not clear the windscreen effectively | 2 |
| Exhaust mounting missing |7.1.1b| | 1 |
| Emissions not tested |7.0| | 1 |
| Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Nearside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Brake pedal has insufficient reserve travel (1.1.2 (a)) | 1 |
| Exhaust has a major leak of exhaust gases Centre exhaust box has a hole (6.1.2 (a)) | 1 |
| Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b)) | 1 |
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
| Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Nearside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
| Nearside Front Headlamp not working on main beam |1.7.5a| | 1 |
| Brakes imbalanced across an axle | 1 |
| Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
| Brake hydraulic reservoir fluid level below minimum level |3.6.G.1b| | 1 |
| Nearside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Front Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
| Offside Indicator tell tale inoperative |1.4.A.2a| | 1 |
| Offside Front Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
| Nearside Obligatory mirror seriously damaged, affecting the rear view |8.1.2a| | 1 |
| Nearside Front Lower Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 1 |
| Nearside Front Steering component mounting prescribed area is excessively corroded steering box mount |2.2.C.1h| | 1 |
| Nearside Front Lower Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2| | 1 |
| Nearside Rear Body has a projection caused by corrosion trim loose with screw hanging from it |6.1.C.1| | 1 |
| Nearside Front Inner Suspension component mounting prescribed area is excessively corroded wing |2.4.A.3| | 1 |
| Nearside Front Side repeater not working |1.4.A.2c| | 1 |
| Hazard warning lamps inoperative nsf wing osr indicator |1.4.B.1b| | 1 |
| Nearside Front Passenger`s seat insecure |6.2.A.1| | 1 |
| Service brake: efficiency below requirements |3.7.C.1a| | 1 |
| Parking brake: efficiency below requirements |3.7.C.1b| | 1 |
| Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Offside Headlamp aim not tested |1.8.A.1c| | 1 |
| Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 1 |
| Indicator tell tale inoperative |1.4.A.2a| | 1 |
| Offside Obligatory mirror seriously damaged, affecting the rear view |8.1.2a| | 1 |
| Parking brake: efficiency below requirements |3.7.B.7| | 1 |
| Nearside Rear Body has a projection caused by damage |6.1.C.1| | 1 |
| Registration plate issues | 1 |
| Rear parking brake recording little or no effort | 1 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Front Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 1 |
| Offside Rear fog lamp not working |1.3.2b| | 1 |