Most common failures | No# failures |
---|
Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 16 |
Headlamp aim out of alignment | 11 |
Registration plate lamp issues | 11 |
Windscreen wiper does not clear the windscreen effectively | 7 |
Offside Rear fog lamp emits a light other than red |1.3.2e| | 4 |
Exhaust emissions carbon monoxide content at idle excessive |7.3.D.4| | 4 |
Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3| | 4 |
Parking brake lever has no reserve travel |3.1.6b| | 4 |
Exhaust emissions hydrocarbon content after 2nd fast idle excessive |7.3.D.3| | 3 |
Offside front brake binding |3.7.B.1| | 3 |
Brake pipe excessively corroded | 3 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 2 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 2 |
Emissions not tested |7.0| | 2 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Stop lamp not working |1.2.1b| | 2 |
Offside Front position lamp|s| not working |1.1.A.3b| | 2 |
Offside Rear fog lamp missing |1.3.2a| | 2 |
Centre Stop lamp not working |1.2.1b| | 2 |
Nearside Front Headlamp not working on dipped beam |1.7.5a| | 2 |
Horn not working |1.6.2a| | 2 |
Parking brake: efficiency below requirements |3.7.B.7| | 2 |
Rear fog lamp not working |4.5.1 |a| |ii|| | 2 |
Offside Rear Coil spring fractured or broken |5.3.1 |b| |i|| | 2 |
Exhaust carbon monoxide content after 2nd fast idle exceeds default limits |8.2.1.2 |b|| | 2 |
Offside Rear fog lamp not working |1.3.2b| | 2 |
Brakes imbalanced across an axle | 1 |
Registration plate issues | 1 |
Front brake excessively fluctuating | 1 |
Centre Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Offside Rear Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Front position lamp|s| has less than 50% of the light sources illuminating |1.1.A.3b| | 1 |
Front Horn not working |1.6.2a| | 1 |
Front Headlamp has a product on the lens so that the light output is severely reduced both |1.7.5a| | 1 |
Offside Steering arm fractured and unserviceable rackend |2.2.C.1d| | 1 |
Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sille panel |6.1.B.2| | 1 |
Nearside Front Lower Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside Parking brake inoperative on one side |1.4.1 |a|| | 1 |
Parking brake lever has excessive movement indicating incorrect adjustment |1.1.6 |c|| | 1 |
Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer`s specified limits |8.2.1.2 |a|| | 1 |
Exhaust Lambda reading after 2nd fast idle outside specified limits |8.2.1.2 |c|| | 1 |
Service brake efficiency below requirements |1.2.2 |a| |i|| | 1 |
Parking brake efficiency below requirements |1.4.2 |a| |i|| | 1 |
Offside Rear brake caliper leaking |3.6.A.1| | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Nearside Rear Rear position lamp|s| incorrect colour |1.1.A.3e| | 1 |
Nearside Headlamp aim beam image kick up to the offside |1.8| | 1 |
Offside Headlamp aim beam image kick up to the offside |1.8| | 1 |
Anti-lock braking system warning lamp indicates an ABS fault | 1 |
Offside Front front brake binding |3.7.B.1| | 1 |
Offside Rear Road wheel badly damaged |4.2.A.1a| | 1 |
rear parking |secondary| brakes imbalanced | 1 |
Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
Offside Headlamp insecure |1.7.3| | 1 |
Offside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Front Headlamp aim projected beam image is obviously incorrect |4.1.2 |c|| | 1 |
Nearside Rear Parking |secondary brake| on a single line braking system has inadequate effort at a wheel |1.3.1 |a| |i|| | 1 |
Rear fog lamp switch missing |4.5.3 |a| |ii|| | 1 |
Nearside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Offside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Offside Rear Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Nearside Rear Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Rear Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Rear parking brake recording little or no effort | 1 |
Nearside Rear Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Rear fog lamp tell tale not working |1.3.1b| | 1 |
Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill |7.1.1 |a| |i|| | 1 |
Offside Seat belt anchorage likely to become detached in the event of a collision outer sill |7.1.1 |a| |ii|| | 1 |
Offside Front Anti-roll bar linkage fractured |2.4.G.1| | 1 |
Offside Obligatory mirror seriously damaged, affecting the rear view |8.1.2a| | 1 |
Rear brake binding | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Offside Front Service brake indicates brake bind |3.7.D.2a| | 1 |
Front Service brake application uneven across the axle |3.7.D.2b| | 1 |
Rear Mechanical brake component has restricted free movement | 1 |
Nearside Front Headlamp light intensity severely reduced |4.1.4 |a|| | 1 |
Offside Front Headlamp light intensity severely reduced |4.1.4 |a|| | 1 |
Steering wheel has excessive movement up and down |2.2.2 |a|| | 1 |
Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill |5.3.6 |a| |i|| | 1 |
Offside Seat belt anchorage prescribed area strength or continuity significantly reduced |7.1.1 |a| |i|| | 1 |
Rear fog lamp not working |1.3.2b| | 1 |
Anti-lock braking system warning lamp does not illuminate |3.4.1b| | 1 |
Offside Front Braking system leaking |3.6.A.1| | 1 |
Offside Front Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Power steering component|s| leaking |2.3.3b| | 1 |
Nearside Outer Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |