Most common failures | No# failures |
---|
Brake pipe excessively corroded | 9 |
Windscreen wiper does not clear the windscreen effectively | 9 |
Headlamp aim out of alignment | 9 |
Registration plate lamp issues | 4 |
Offside Rear Anti-roll bar linkage has excessive play in a ball joint |2.4.G.2| | 3 |
Nearside Headlamp has a product on the lens so that the light output is severely reduced |1.7.5a| | 3 |
Offside Headlamp has a product on the lens so that the light output is severely reduced |1.7.5a| | 3 |
Parking brake: efficiency below requirements |3.7.B.7| | 3 |
Registration plate issues | 3 |
Offside Stop lamp not working |1.2.1b| | 2 |
Rear parking brake recording little or no effort | 2 |
Offside Rear Stop lamp not working |1.2.1b| | 2 |
Offside Rear Rear fog lamp not working |1.3.2b| | 2 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Front brake application uneven | 2 |
Nearside Rear Anti-roll bar linkage has excessive play in a ball joint |2.4.G.2| | 2 |
Offside Front Front position lamp|s| not working |1.1.A.3b| | 2 |
brake disc excessively pitted |3.5.1h| | 1 |
Offside Front Anti-roll bar linkage has excessive play in a ball joint |2.4.G.2| | 1 |
Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Nearside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Nearside Service brake excessively fluctuating (1.2.1 (e)) | 1 |
Nearside Front Service brake excessively binding (1.2.1 (f)) | 1 |
Offside Front Service brake excessively binding (1.2.1 (f)) | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i)) | 1 |
Fuel pipe insecure filler neck corroded (6.1.3 (a) (i)) | 1 |
Nearside Front Floor excessively deteriorated corroded near within 30cm of seat mount (6.2.4 (a) (i)) | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill |5.3.6 |a| |i|| | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill |5.3.6 |a| |i|| | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor pan |5.3.6 |a| |i|| | 1 |
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch / engine mounting |5.3.6 |a| |i|| | 1 |
Offside Sub-frame corroded and seriously weakened |5.3.3 |b| |i|| | 1 |
Nearside Front Position lamp not working |4.2.1 |a|| | 1 |
Offside Front Position lamp not working |4.2.1 |a|| | 1 |
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Strut top |5.3.6 |a| |i|| | 1 |
Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill |5.3.6 |a| |i|| | 1 |
Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill |5.3.6 |a| |i|| | 1 |
Offside Front Sub-frame corroded to the extent that the rigidity of the assembly is significantly reduced |6.1.1 |c| |i|| | 1 |
Nearside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Offside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Nearside Front brake disc excessively pitted |3.5.1h| | 1 |
Offside Front brake disc excessively pitted |3.5.1h| | 1 |
Front Vehicle structure has an inadequate repair which adversely affects braking or steering |6.1.A.1| | 1 |
Nearside Steering locking device missing |2.2.C.1g| | 1 |
Offside Steering locking device missing |2.2.C.1g| | 1 |
Offside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Nearside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Centre Front Exhaust system not adequately supported exhaust brackets at front section corroded and not attached |7.1.1| | 1 |
Offside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement rear rubber bush separating |2.4.G.2| | 1 |
Nearside Front Lower Anti-roll bar linkage has excessive play in a ball joint |2.4.G.2| | 1 |
Nearside Front Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Offside Rear Tie bar/rod has excessive play in a ball joint |2.4.G.2| | 1 |
Offside Front Tie bar/rod has excessive play in a ball joint |2.4.G.2| | 1 |
Brake hose has insufficient room to move | 1 |
Offside Rear Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2| | 1 |
Battery insecure |1.9.1| | 1 |
Nearside Rear Road wheel bead rim badly distorted |4.2.A.1a| | 1 |
Brakes imbalanced across an axle | 1 |
Centre Exhaust system not adequately supported |7.1.1| | 1 |
Rear fog lamp not working |1.3.2b| | 1 |
Nearside front brake binding |3.7.B.1| | 1 |
Nearside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Offside Front Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Battery leaking electrolyte |1.9.1| | 1 |
Nearside Front front brake binding |3.7.B.1| | 1 |
Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h)) | 1 |
Nearside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Rear fog lamp missing |1.3.2a| | 1 |
Offside Front Headlamp aim so that beam "kick up" is not visible on the screen |4.1.2 |a|| | 1 |
Offside Rear Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Statutory seat belt missing |5.1.1| | 1 |
Nearside Rear Outer Body has a projection caused by corrosion |6.1.C.1| | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Front suspension ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Offside Front suspension ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Offside front brake binding |3.7.B.1| | 1 |
Offside Obligatory mirror insecure |8.1.1| | 1 |
Nearside Front Wheel nut|s| missing |4.2.A.1e| | 1 |
Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 1 |
Anti-lock braking system warning lamp indicates an ABS fault | 1 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Offside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Braking system leaking |3.6.A.1| | 1 |
Rear brake application uneven | 1 |
Offside Rear Trailing arm rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Offside Rear Shock absorber has a serious fluid leak |2.7.3| | 1 |
Nearside Front Direction indicator incorrect colour (4.4.3 (a)) | 1 |
Offside Front Direction indicator incorrect colour (4.4.3 (a)) | 1 |
Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b)) | 1 |
Nearside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
Offside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
Nearside Rear Shock absorbers has a serious fluid leak | 1 |
Offside Rear Shock absorbers has a serious fluid leak | 1 |
Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i)) | 1 |
Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i)) | 1 |
Offside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
Nearside Rear Shock absorber has a serious fluid leak |2.7.3| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Anti-roll bar has excessive play in a ball joint |2.4.G.2| | 1 |
Nearside Front Anti-roll bar has excessive play in a ball joint |2.4.G.2| | 1 |
Nearside Front Outer Subframe mounting prescribed area is excessively corroded Side sill |2.4.A.3| | 1 |
Nearside Front Inner Subframe mounting prescribed area is excessively corroded Side sill |2.4.A.3| | 1 |
Offside Rear Outer Anti-roll bar has excessive play in a ball joint Link |2.4.G.2| | 1 |
Nearside Rear Body has a sharp edge caused by damage Light lens |6.1.C.1| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded sill stop end |2.4.A.3| | 1 |
Offside Outer Front Anti-roll bar has excessive play in a ball joint |2.4.G.2| | 1 |