| Most common failures | No# failures |
|---|
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 3 |
| Nearside Front Service brake excessively binding (1.2.1 (f)) | 2 |
| Offside Front Service brake excessively binding (1.2.1 (f)) | 2 |
| Nearside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 2 |
| Offside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 2 |
| Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 2 |
| Offside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
| Offside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
| Nearside Rear Lower Suspension arm damaged and seriously weakened (5.3.3 (b) (i)) | 1 |
| Windscreen wiper does not clear the windscreen effectively | 1 |
| Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Nearside Rear Parking brake inoperative on one side (1.4.1 (a)) | 1 |
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
| Brakes imbalanced across an axle | 1 |
| Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 1 |
| Offside Body has a sharp edge caused by damage |6.1.C.1| | 1 |
| Brake performance not tested (1.2.1 (g)) | 1 |
| Nearside Front Hydraulic brake calliper damaged Partially seized (1.1.16 (a) (i)) | 1 |
| Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b)) | 1 |
| Offside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b)) | 1 |
| Offside Front Direction indicator not working (4.4.1 (a) (ii)) | 1 |
| Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength two areas (5.3.6 (a) (i)) | 1 |
| Rear fog lamp missing (4.5.1 (a) (ii)) | 1 |
| Horn not working (7.7 (a)) | 1 |
| Rear Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
| Emissions unable to be completed (8.2.1.2 (d)) | 1 |
| Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a)) | 1 |
| Offside Rear Rear fog lamp light intensity significantly reduced (4.5.4 (a)) | 1 |