>

MOT History from tests of petrol MAZDA MPVs year 2011

Review the list of common MAZDA MPV failures below or to perform a specific mot history check on your MAZDA then use our popular KnowYourCar service

mot history
Pass percent:75.41%
(The average a petrol MAZDA MPV year 2011 passes without issue)
Based on:61 MOT Tests
Most common failuresNo# failures
Windscreen wiper does not clear the windscreen effectively3
Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a))3
Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a))2
Anti-lock braking system warning lamp indicates an ABS fault2
Nearside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))2
Offside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))2
Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))2
Registration plate lamp issues2
Nearside Front Headlamp levelling device inoperative (4.1.5 (a))1
Offside Front Headlamp levelling device inoperative (4.1.5 (a))1
Nearside Front Service brake excessively binding (1.2.1 (f))1
Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))1
Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected rear inner wings (5.3.6 (a) (ii))1
Offside Front Lower Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))1
Offside Power steering ram leaking (2.1.5 (a))1
Windscreen washer not working 1
Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))1
Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))1
Offside Front Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))1
Offside Front Lower Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))1
Brake pipe excessively corroded1
Service brake efficiency below requirements (1.2.2 (a) (i))1
Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))1
Nearside Front Battery insecure and likely to fall from carrier (4.13 (a) (ii))1
Nearside Front Headlamp aim projected beam image is obviously incorrect lens needs polishing (4.1.2 (c))1
Offside Front Headlamp aim projected beam image is obviously incorrect lens needs polishing (4.1.2 (c))1
Offside Rear Rear fog lamp light intensity significantly reduced (4.5.4 (a))1
Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))1
Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill (6.2.2 (d) (i))1
Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill (6.2.2 (d) (i))1
Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill (6.2.2 (d) (i))1
Front Headlamp has a product on the lens so that the light output is severely reduced both sides (4.1.4 (b))1
Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced out rigger (6.1.1 (c) (i))1
Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced out rigger (6.1.1 (c) (i))1
Nearside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting outer sill (6.2.2 (d) (i))1
Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))1
Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))1
Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength crossmember (5.3.6 (a) (i))1
Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))1
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength innersill (5.3.6 (a) (i))1
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength arch (5.3.6 (a) (i))1
Offside Stop lamp(s) not working (4.3.1 (a) (ii))1
Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))1
Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floorpan (5.3.6 (a) (i))1
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floorpan (5.3.6 (a) (i))1
Headlamp aim out of alignment1
Rear fog lamp missing (4.5.1 (a) (ii))1
Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))1
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))1
Nearside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))1
Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))1
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))1
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))1
Brake pedal has insufficient reserve travel (1.1.2 (a))1
Nearside Headlamp lens seriously defective (4.1.1 (b) (ii))1
Offside Headlamp lens seriously defective (4.1.1 (b) (ii))1
Central Exhaust has a major leak of exhaust gases (6.1.2 (a))1
Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))1
Emissions not tested exhaust blow (8.2.1.2 (d))1
Parking brake efficiency below requirements (1.4.2 (a) (i))1
Rear fog lamp switch missing |1.3.1a|1
Nearside Rear passenger door cannot be opened from outside the vehicle |6.2.B.1c|1
Nearside Stop lamp(s) not working (4.3.1 (a) (ii))1
Offside Front Position lamp not working (4.2.1 (a) (ii))1

We get to these numbers by trawling through over 1 billion MOT test results since 2004 and crunched the numbers. We remove anything to do with Tyres, as they are model independent and group together common non-model specific issues. We are trying to get to a picture of what models have what issues.

Please note: We take the data from the DVSA. This data is raw and can contain typos and spelling mistakes that garages may have entered while recording a MOT result. Specifically miss-match on names of models and makes. We are constantly cleaning the data so bear with the odd issue.

Got suggestions? We’re improving this section all the time. If you have any suggestions, please let us know.

Find us on Facebook

© KnowYourCar™ 2019. All rights reserved
Except where otherwise noted, content on our MOT statistics pages are licensed under a Creative Commons Attribution 4.0 International license.
You are free to redistribute the material in any medium or format as long as credit is given to KnowYourCar

WARNING: We have placed hidden watermarks in our data. We will take action against our data being used outside of these terms.

MOT Data licensed under the Open Government Licence v3.0

By using our site you are agreeing to our terms and conditions
Terms & Conditions  Privacy Policy