| Most common failures | No# failures |
|---|
| Windscreen wiper does not clear the windscreen effectively | 13 |
| Offside Rear fog lamp not working |1.3.2b| | 8 |
| Registration plate lamp issues | 6 |
| Registration plate issues | 3 |
| Rear fog lamp not working |1.3.2b| | 3 |
| Headlamp aim out of alignment | 3 |
| Nearside Front Anti-roll bar linkage has excessive play in a ball joint |2.4.G.2| | 2 |
| Offside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Horn not working |1.6.2a| | 2 |
| Offside Stop lamp not working |1.2.1b| | 2 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Nearside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Offside Front position lamp|s| not working |1.1.A.3b| | 2 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Parking brake: efficiency below requirements |3.7.B.7| | 2 |
| Front brake disc in such a condition that it is seriously weakened | 2 |
| Exhaust emits an excessive level of metered smoke for a non-turbo charged engine |7.4.B.3b| | 1 |
| Offside Front Lower Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt |5.3.4 |b| |ii|| | 1 |
| Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced rear crossmember, 3rd row seatbelt mounts |7.1.1 |a| |i|| | 1 |
| Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Rear Anti-roll bar attachment bracket/mounting insecure |2.4.G.1| | 1 |
| Fuel cap/sealing device does not fasten securely by positive means |7.2.4b| | 1 |
| Offside Headlamp aim not tested |1.8.A.1c| | 1 |
| Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Offside Headlamp not working on main beam |1.7.5a| | 1 |
| Offside Seat belt anchorage prescribed area is excessively corroded roof above c-post |5.2.6| | 1 |
| Offside Outer Seat belt anchorage prescribed area is excessively corroded Sill bottom of b-post |5.2.6| | 1 |
| Offside Front Vehicle structure has excessive corrosion which adversely affects braking or steering A-pillar |6.1.A.1| | 1 |
| Offside Rear Outer Seat belt anchorage prescribed area is excessively corroded Sill area |5.2.6| | 1 |
| Offside Inner Seat belt anchorage prescribed area is excessively corroded Sill B-post area |5.2.6| | 1 |
| Offside Rear Inner Seat belt anchorage prescribed area is excessively corroded sill area centre and rear seatbelt mountings |5.2.6| | 1 |
| Nearside Front Inner Seat belt anchorage prescribed area is excessively corroded Sill, B-post |5.2.6| | 1 |
| Offside Rear Inner Seat belt anchorage prescribed area is excessively corroded Arch |5.2.6| | 1 |
| Nearside Rear Inner Seat belt anchorage prescribed area is excessively corroded Arch |5.2.6| | 1 |
| Nearside Front Subframe mounting prescribed area is excessively corroded inner sill |2.4.A.3| | 1 |
| Nearside Front Subframe mounting prescribed area is excessively corroded inner arch |2.4.A.3| | 1 |
| Windscreen has damage | 1 |
| Offside Rear Anti-roll bar attachment bracket/mounting corroded and its strength is seriously reduced |2.4.G.1| | 1 |
| Offside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Offside Inner Suspension component mounting prescribed area is excessively corroded sill |2.4.A.3| | 1 |
| Nearside Front Inner Suspension component mounting prescribed area is excessively corroded sill |2.4.A.3| | 1 |
| Nearside Rear Outer Suspension component mounting prescribed area is excessively corroded sill |2.4.A.3| | 1 |
| Offside Rear Outer Suspension component mounting prescribed area is excessively corroded sill |2.4.A.3| | 1 |
| Power steering component|s| leaking steering rack |2.3.3b| | 1 |
| Offside Rear Stop lamp not working |1.2.1b| | 1 |
| Rear Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
| Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength front cross member (5.3.6 (a) (i)) | 1 |
| Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Parking brake lever has no reserve travel |3.1.6b| | 1 |
| Offside Steering rack gaiter split |2.2.D.2d| | 1 |
| Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner sil |6.1.B.2| | 1 |
| Central Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings crossmember |6.1.B.2| | 1 |
| Exhaust emits an excessive level of metered smoke for a turbo charged engine |7.4.B.3b| | 1 |
| Nearside Rear Rear fog lamp not working |1.3.2b| | 1 |
| Offside Rear Anti-roll bar linkage pin or bush excessively worn |5.3.4 |a| |i|| | 1 |
| Nearside Rear Anti-roll bar linkage pin or bush excessively worn |5.3.4 |a| |i|| | 1 |
| Nearside Front Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected |5.3.6 |a| |ii|| | 1 |
| Rear fog lamp not working |4.5.1 |a| |ii|| | 1 |
| Nearside Parking brake inoperative on one side |1.4.1 |a|| | 1 |
| Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
| Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting outer sill (6.2.2 (d) (i)) | 1 |
| Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill (6.2.2 (d) (i)) | 1 |
| Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting crossmember (6.2.2 (d) (i)) | 1 |
| Nearside Rear Lower Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 1 |
| Nearside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Offside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded inner wing |under bonnet| |2.4.A.3| | 1 |
| Offside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner outer sills |6.2.2 |d| |i|| | 1 |
| Offside Front Anti-roll bar ball joint excessively worn |5.3.4 |a| |i|| | 1 |
| Rear parking brake recording little or no effort | 1 |
| Nearside Inner Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Inner Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside rear brake recording little or no effort |3.7.B.5a| | 1 |
| Offside rear brake recording little or no effort |3.7.B.5a| | 1 |
| Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
| Rear Rear fog lamp not working |1.3.2b| | 1 |
| Offside Windscreen wiper blade missing |8.2.2| | 1 |
| Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Rear Anti-roll bar attachment bracket/mounting nut missing |2.4.G.1| | 1 |
| Nearside Front Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
| Offside Front Anti-roll bar rubber mounting bonding deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Nearside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i)) | 1 |
| Offside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i)) | 1 |
| Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting outrigger (6.2.2 (d) (i)) | 1 |
| Nearside Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting plate not welded correctly (6.2.2 (d) (i)) | 1 |
| Nearside Front Headlamp light intensity severely reduced (4.1.4 (a)) | 1 |
| Offside Front Headlamp light intensity severely reduced (4.1.4 (a)) | 1 |
| Nearside Rear Coil spring corroded so that its cross sectional area is reduced and seriously weakened (5.3.1 (b) (i)) | 1 |
| Offside Rear Coil spring corroded so that its cross sectional area is reduced and seriously weakened (5.3.1 (b) (i)) | 1 |
| Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength SILL (5.3.6 (a) (i)) | 1 |
| Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Emissions not tested |7.0| | 1 |
| Nearside Front Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
| Offside Front Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
| Centre Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Offside Rear Rear fog lamp not working |1.3.2b| | 1 |
| Offside Rear Anti-roll bar attachment bracket/mounting cracked |2.4.G.1| | 1 |
| Nearside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded crossmember |2.4.A.3| | 1 |
| Offside Front Suspension component mounting prescribed area is deliberately modified which significantly reduces the original strength crossmember |2.4.A.3| | 1 |
| Nearside Front Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Offside Suspension spring mounting prescribed area is excessively corroded outer sill |2.4.A.3| | 1 |
| Offside Front Subframe mounting prescribed area is excessively corroded inner sill |2.4.A.3| | 1 |
| Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Nearside Front Lower Suspension arm has excessive play in a pin/bush |2.4.G.2| | 1 |
| Offside Front Lower Suspension arm has excessive play in a pin/bush |2.4.G.2| | 1 |
| Offside Front Anti-roll bar linkage has excessive play in a ball joint |2.4.G.2| | 1 |
| Suspension component mounting prescribed area excessively corroded significantly reducing structural strength both sides inner sills front and rear N/S, Front O/S, and O/S front toeing eye mounting |5.3.6 |a| |i|| | 1 |
| Rear Seat belt missing Stork |7.1.2 |a|| | 1 |
| Rear Stop lamp(s) all not working (4.3.1 (a) (iii)) | 1 |
| Nearside Front front brake binding |3.7.B.1| | 1 |