Most common failures | No# failures |
---|
Nearside Stop lamp(s) not working (4.3.1 (a) (ii)) | 4 |
Registration plate lamp issues | 4 |
Offside Front position lamp|s| not working |1.1.A.3b| | 3 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 3 |
Rear parking brake recording little or no effort | 3 |
Driver`s seat insecure |6.2.A.1| | 2 |
Nearside Front Service brake excessively binding (1.2.1 (f)) | 2 |
Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 2 |
Windscreen washer not working | 2 |
Parking brake: efficiency below requirements |3.7.B.7| | 2 |
Offside Front Position lamp not working (4.2.1 (a) (ii)) | 2 |
Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 2 |
Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 2 |
Headlamp aim out of alignment | 2 |
Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 2 |
Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 2 |
Offside Front Position lamp not working |4.2.1 |a|| | 1 |
Nearside Headlamp cleaning device inoperative |1.7.2| | 1 |
Offside Headlamp cleaning device inoperative |1.7.2| | 1 |
Nearside Rear Valve stem seriously damaged |4.1.D.1e| | 1 |
Offside Rear Anti-roll bar linkage pin or bush likely to become detached |5.3.4 |a| |ii|| | 1 |
Offside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Offside Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |
Stop lamp(s) all not working (4.3.1 (a) (iii)) | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
Brakes imbalanced across an axle | 1 |
Offside Rear Body has a sharp edge caused by damage |6.1.C.1| | 1 |
Nearside Rear Body has a sharp edge caused by damage |6.1.C.1| | 1 |
Front brake application uneven | 1 |
brake disc in such a condition that it is seriously weakened |3.5.1i| | 1 |
Offside Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
Offside Front Service brake excessively binding (1.2.1 (f)) | 1 |
Nearside Front Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i)) | 1 |
Nearside Rear Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i)) | 1 |
Nearside Front Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i)) | 1 |
Offside Rear Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i)) | 1 |
Offside Front Lower Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced cross member (6.1.1 (c) (i)) | 1 |
Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 1 |
Parking brake: efficiency below requirements (3.7.B.7) | 1 |
Front Headlamp cleaning device inoperative (1.7.2) | 1 |
Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Offside Front Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i)) | 1 |
Rear Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Exhaust has a major leak of exhaust gases centre (6.1.2 (a)) | 1 |
Anti-roll bar pin or bush excessively worn both rear D bushes (5.3.4 (a) (i)) | 1 |
Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
Offside Front Suspension arm corroded and seriously weakened (5.3.3 (b) (i)) | 1 |
Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 1 |
Nearside Rear Position lamp showing white light to the rear damaged (4.2.3 (a) (ii)) | 1 |
Offside Rear Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
Central Rear Seat belt buckle missing (7.1.2 (d)) | 1 |
Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Door Sill (5.3.6 (a) (i)) | 1 |
Rear fog lamp does not emit a steady red light (4.5.4 (a)) | 1 |
Offside Rear Suspension component mounting prescribed area is inadequately repaired (5.3.6 (a) (i)) | 1 |
Nearside Front Suspension component mounting prescribed area is inadequately repaired inner wheel arch (5.3.6 (a) (i)) | 1 |
Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength crossmember (5.3.6 (a) (i)) | 1 |
Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i)) | 1 |
Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i)) | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i)) | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i)) | 1 |
Nearside Rear Anti-roll bar linkage missing (5.3.3 (a) (ii)) | 1 |
Nearside Vehicle structure is so weakened by corrosion within 30cm of a towbar mounting, the towbar is likely to become detached (6.1.6 (i) (ii)) | 1 |
Offside Vehicle structure excessively corroded within 30cm of towbar mounting (6.1.6 (i) (i)) | 1 |
Central Vehicle structure excessively corroded within 30cm of towbar mounting rear crossmember not repaired adequately (6.1.6 (i) (i)) | 1 |
Fuel tank leaking (6.1.3 (b) (i)) | 1 |
Anti-lock braking system warning lamp indicates an ABS fault | 1 |
Nearside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i)) | 1 |
Rear fog lamp does not emit a steady red light Incorrect colour (4.5.4 (a)) | 1 |
Windscreen wiper does not clear the windscreen effectively | 1 |
Nearside Headlamp has a product on the light source so that the light output is severely reduced (4.1.4 (b)) | 1 |
Offside Headlamp has a product on the lens which changes emitted colour to other than white or yellow (4.1.4 (b)) | 1 |
Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Oil leaking excessively from engine (8.4.1 (a) (i)) | 1 |
Nearside Front Suspension component mounting prescribed area excessively damaged significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced Inner sill (7.1.1 (a) (i)) | 1 |
Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced Outer sill (7.1.1 (a) (i)) | 1 |
Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
Driver`s seat moving inadvertently |6.2.5 |b| |ii|| | 1 |
Driver`s seat insecure |6.2.5 |a| |ii|| | 1 |
Driver`s seat with a defective structure |6.2.5 |a| |i|| | 1 |
Nearside Front Position lamp not working |4.2.1 |a| |ii|| | 1 |
Offside Front Position lamp not working |4.2.1 |a| |ii|| | 1 |
Nearside Front Upper Suspension arm ball joint excessively worn |5.3.4 |a| |i|| | 1 |
Offside Front Lower Suspension arm ball joint excessively worn |5.3.4 |a| |i|| | 1 |
Nearside Front Front wheel bearing has excessive play |2.5.A.3c| | 1 |