| Most common failures | No# failures |
|---|
| Windscreen wiper does not clear the windscreen effectively | 8 |
| Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b)) | 4 |
| Exhaust emissions carbon monoxide content at idle excessive |7.3.D.4| | 4 |
| Registration plate lamp issues | 3 |
| Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3| | 2 |
| Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 2 |
| Offside Front Position lamp not working (4.2.1 (a) (ii)) | 2 |
| Nearside Front position lamp|s| not working |1.1.A.3b| | 2 |
| Headlamp aim out of alignment | 2 |
| Windscreen has damage | 2 |
| Rear fog lamp missing (4.5.1 (a) (ii)) | 1 |
| Nearside Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
| Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Brake performance not tested (1.2.1 (g)) | 1 |
| Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Exhaust emits excessive dense blue smoke during acceleration (8.2.1.2 (g)) | 1 |
| Exhaust emits dense blue smoke at idle (8.2.1.2 (f)) | 1 |
| Offside Stop lamp not working |1.2.1b| | 1 |
| Offside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill |6.1.B.2| | 1 |
| Central Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Nearside Rear Stop lamp not working |1.2.1b| | 1 |
| Drivers view of the road through the swept area of the windscreen materially affected by an obstruction (3.1 (a) (ii)) | 1 |
| Offside Rear Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill |6.1.B.2| | 1 |
| Nearside front brake binding |3.7.B.1| | 1 |
| Brakes imbalanced across an axle | 1 |
| Offside Front Wheel nut|s| missing x1 |4.2.A.1e| | 1 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
| Anti-lock braking system warning lamp indicates an ABS fault | 1 |
| Rear fog lamp not working |4.5.1 |a| |ii|| | 1 |
| Offside Front Position lamp not working |4.2.1 |a|| | 1 |
| Rear fog lamp not working |1.3.2b| | 1 |
| Nearside Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill marked with chalk (5.3.6 (a) (i)) | 1 |
| Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
| Brake hydraulic reservoir cap missing (1.1.10 (e)) | 1 |
| Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill (5.3.6 (a) (i)) | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill (5.3.6 (a) (i)) | 1 |
| Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement |7.2.4b| | 1 |
| Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c)) | 1 |
| Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b)) | 1 |
| Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i)) | 1 |
| Nearside Rear Inner Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Chassis |5.3.6 |a| |i|| | 1 |
| Nearside Rear All position lamps not working |4.2.1 |a|| | 1 |
| Offside Rear Stop lamp not working |1.2.1b| | 1 |
| Nearside Front Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Battery insecure and likely to fall from carrier (4.13 (a) (ii)) | 1 |
| Rear fog lamp does not emit a steady red light |4.5.4 |a|| | 1 |
| Exhaust carbon monoxide content after 2nd fast idle exceeds default limits |8.2.1.2 |b|| | 1 |
| Windscreen washer not working | 1 |
| Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
| Rear fog lamp missing |1.3.2a| | 1 |
| Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Offside Rear fog lamp with a multiple light source more than 1/2 not functioning (4.5.1 (a) (ii)) | 1 |
| Nearside Front Upper Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Nearside Rear Lower Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Offside Rear Lower Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Nearside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Offside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a)) | 1 |
| Offside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill to floor (6.1.1 (c) (i)) | 1 |
| Offside Front Bumper insecure |6.1.4 |a| |i|| | 1 |
| Rear fog lamp missing |4.5.1 |a| |ii|| | 1 |
| Nearside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
| Nearside Front Body component damaged and likely to cause injury WHEEL ARCH |6.2.1 |a| |i|| | 1 |
| Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer`s specified limits |8.2.1.2 |a|| | 1 |
| Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
| Rear fog lamp switch inoperative (4.5.3 (a)) | 1 |
| Front Position lamp not working both (4.2.1 (a) (ii)) | 1 |
| Rear Position lamp not working both (4.2.1 (a) (ii)) | 1 |
| Nearside Position lamp not working |4.2.1 |a|| | 1 |
| Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Offside Rear Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement lower |2.4.G.2| | 1 |
| Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement D bush |2.4.G.2| | 1 |
| Offside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement D bush |2.4.G.2| | 1 |
| Nearside Front Lower Suspension arm ball joint dust cover insecure so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Offside Front Lower Suspension arm ball joint dust cover insecure so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Offside Front Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Nearside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Offside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Nearside rear brake excessively fluctuating |3.7.B.3| | 1 |
| Offside rear brake excessively fluctuating |3.7.B.3| | 1 |