| Most common failures | No# failures |
|---|
| Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 4 |
| Brake pipe excessively corroded | 3 |
| Windscreen wiper does not clear the windscreen effectively | 3 |
| Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 2 |
| Offside Rear Rear fog lamp emits a light other than red (1.3.2e) | 2 |
| Anti-lock braking system warning lamp indicates an ABS fault | 2 |
| Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii)) | 2 |
| Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 2 |
| Nearside Stop lamp(s) not working (4.3.1 (a) (ii)) | 2 |
| Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 2 |
| Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c)) | 2 |
| Offside Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
| Offside Rear Rear fog lamp does not emit a steady red light (4.5.4 (a)) | 1 |
| Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings center cill hole** (6.1.B.2) | 1 |
| Nearside Front Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings cill has hole** (6.1.B.2) | 1 |
| Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings cill has hole** (6.1.B.2) | 1 |
| Nearside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2) | 1 |
| Exhaust has a major leak of exhaust gases exhaust flexi blowing (7.1.2) | 1 |
| Emissions not tested (7.3.A.1) | 1 |
| Nearside Front position lamp(s) not working (1.1.A.3b) | 1 |
| Offside Side repeater missing (4.4.1 (a) (ii)) | 1 |
| Rear Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
| Nearside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Offside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Spare wheel carrier insecure (6.1.5 (a)) | 1 |
| Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
| Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
| Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i)) | 1 |
| Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sill (5.3.6 (a) (i)) | 1 |
| Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner floor (5.3.6 (a) (i)) | 1 |
| Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
| Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
| Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i)) | 1 |
| Front Lower Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced both sides (6.1.1 (c) (i)) | 1 |
| Offside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced wing arch area (7.1.1 (a) (i)) | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength near top Shock absorber mount (5.3.6 (a) (i)) | 1 |
| Offside Front Service brake excessively binding (1.2.1 (f)) | 1 |
| Exhaust has a major leak of exhaust gases rear box (6.1.2 (a)) | 1 |
| Rear Stop lamp(s) all not working (4.3.1 (a) (iii)) | 1 |
| Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| Offside Front Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |
| Offside Front Headlamp aim not tested (4.1.2 (b)) | 1 |
| Rear Seat belt missing both (7.1.2 (a)) | 1 |
| Nearside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
| Steering system excessively rough (2.1.1 (a)) | 1 |
| Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength behind wheel (5.3.6 (a) (i)) | 1 |
| Offside Rear fog lamp light intensity significantly reduced (4.5.4 (a)) | 1 |
| Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Front Battery insecure and likely to fall from carrier (4.13 (a) (ii)) | 1 |
| Offside Rear Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
| Nearside Front Steering locking device missing track rod end (2.1.3 (d)) | 1 |
| Offside Front Steering locking device missing track rod end (2.1.3 (d)) | 1 |
| Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
| Nearside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
| Offside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
| Nearside Front Service brake excessively binding (1.2.1 (f)) | 1 |
| Exhaust has a major leak of exhaust gases centre to rear fastening bolts insecure (6.1.2 (a)) | 1 |
| Emissions unable to be completed due to exhaust (8.2.1.2 (d)) | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i)) | 1 |
| Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b)) | 1 |
| Bonnet cannot be secured in the closed position (3.1 (b) (i)) | 1 |
| Offside Front Side repeater not working (4.4.1 (a) (ii)) | 1 |
| Offside Rear Inner Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Nearside Headlamp light intensity severely reduced (4.1.4 (a)) | 1 |
| Offside Headlamp light intensity severely reduced (4.1.4 (a)) | 1 |
| Nearside Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Exhaust emissions likely to be affected by an induction leak (8.2.1.1 (b)) | 1 |
| Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c)) | 1 |
| Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b)) | 1 |
| Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Front Upper Seat belt anchorage prescribed area strength or continuity significantly reduced roof top of B pillar (7.1.1 (a) (i)) | 1 |
| Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sills (5.3.6 (a) (i)) | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sills (5.3.6 (a) (i)) | 1 |
| Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sub frame mount area (5.3.6 (a) (i)) | 1 |
| Fuel cap/sealing device ineffective (6.1.3 (b) (i)) | 1 |