Most common failures | No# failures |
---|
Brake hose excessively deteriorated | 4 |
Headlamp aim out of alignment | 2 |
Registration plate lamp issues | 2 |
Rear parking brake recording little or no effort | 2 |
Parking brake lever has no reserve travel |3.1.6b| | 1 |
Registration plate issues | 1 |
Offside Rear Shock absorber has negligible damping effect |2.7.5| | 1 |
Position lamp switch insecure |1.1.A.1| | 1 |
Nearside Front Braking system leaking |3.6.A.1| | 1 |
Service brake: efficiency below requirements |3.7.D.4| | 1 |
Parking brake: efficiency below requirements |3.7.D.4| | 1 |
Offside Front Steering component mounting prescribed area is excessively corroded |2.2.C.1h| | 1 |
Nearside Outer Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Suspension spring mounting prescribed area is fractured |2.4.A.3| | 1 |
Service brake is causing the steering wheel to severely pull one way |3.7.C.2| | 1 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Service brake: efficiency below requirements |3.7.C.1a| | 1 |
Nearside Windscreen wiper not operating over a large enough area to give an adequate view |8.2.1c| | 1 |
Offside Windscreen wiper not operating over a large enough area to give an adequate view |8.2.1c| | 1 |
Nearside Rear passenger door does not latch securely closed |6.2.B.1a| | 1 |
Offside Rear passenger door does not latch securely closed |6.2.B.1a| | 1 |
Nearside Rear Stop lamp not working |1.2.1b| | 1 |
Offside Rear Stop lamp not working |1.2.1b| | 1 |
Nearside Rear position lamp|s| incorrect colour |1.1.A.3e| | 1 |
Steering system has excessive free play detected at the steering wheel |steering box fitted| |2.2.A.1a| | 1 |
Inner Drag link end ball joint has excessive play |2.2.B.1f| | 1 |
Steering system excessively tight |2.2.D.1| | 1 |
Exhaust engine idle speed too high |7.3.A.2a| | 1 |
Offside Obligatory mirror missing |8.1.1| | 1 |
Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Fuel system component insecure |7.2.1| | 1 |
Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 1 |
Body has a sharp edge caused by damage |6.1.C.1| | 1 |
Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Stop lamp not working |1.2.1b| | 1 |
Rear brake binding | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |
Brakes imbalanced across an axle | 1 |