Most common failures | No# failures |
---|
Parking brake lever has no reserve travel |3.1.6b| | 4 |
Headlamp aim out of alignment | 3 |
Parking brake: efficiency below requirements |3.7.C.1b| | 3 |
Offside Headlamp not working on main beam |1.7.5a| | 2 |
Offside Rear position lamp|s| not working |1.1.A.3b| | 2 |
Nearside Front Leaf spring has excessive wear in a shackle pin and/or bush |2.4.B.2| | 2 |
Offside Rear Lower Shock absorber has an excessively worn bush |2.7.4| | 2 |
Rear brake binding | 2 |
Offside Front wheel bearing has excessive play |2.5.A.3c| | 2 |
Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 2 |
Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Steering system excessively tight |2.2.D.1| | 2 |
Offside rear brake recording little or no effort |3.7.B.5a| | 2 |
Windscreen wiper does not clear the windscreen effectively | 2 |
Stop lamp remains on when the brakes are released | 2 |
Brake pedal anti-slip provision missing |3.3.A.1b| | 1 |
Offside Headlamp aim beam image too far to the right |1.6.B4| | 1 |
Nearside Headlamp not working on main beam |1.7.5a| | 1 |
Nearside Front front brake binding |3.7.B.1| | 1 |
Offside Drag link end ball joint has excessive play |2.2.B.1f| | 1 |
Offside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Offside Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
Registration plate lamp issues | 1 |
Nearside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Front Direction indicator not working |1.4.A.2c| | 1 |
Nearside Front Steering component mounting prescribed area is excessively corroded |2.2.C.1h| | 1 |
Offside Front Steering component mounting prescribed area is excessively corroded |2.2.C.1h| | 1 |
Indicator switch faulty |1.4.A.1| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Track rod end ball pin shank loose |2.2.B.1c| | 1 |
Offside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 1 |
Fuel cap/sealing device sealing washer missing |7.2.4c| | 1 |
Nearside Rear Position lamp not working |4.2.1 |a|| | 1 |
Nearside Front Position lamp not working |4.2.1 |a|| | 1 |
Offside Rear reflector missing |1.5.1a| | 1 |
Offside Front Leaf spring cracked |2.4.B.1a| | 1 |
Nearside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Headlamp insecure |1.7.3| | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Brake linkage has abnormal movement of levers indicating excessive wear |3.5.1f| | 1 |
Offside Front brake drum contaminated by oil |3.5.1h| | 1 |
Nearside Outer Drag link end ball joint has excessive play |2.2.B.1f| | 1 |
Nearside Outer Steering locking device missing |2.2.C.1g| | 1 |
Nearside Outer Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Nearside Front Lower Shock absorber has an excessively worn bush |2.7.4| | 1 |
Offside Front Lower Shock absorber has an excessively worn bush |2.7.4| | 1 |
Nearside Front wheel bearing has excessive play |2.5.A.3c| | 1 |
Windscreen wiper not working (3.4 (a)) | 1 |
Windscreen washer not working | 1 |
Horn not working (7.7 (a)) | 1 |
Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Floor in area of door hinge (6.1.1 (c) (i)) | 1 |
Offside Front Steering component mounting prescribed area is excessively corroded inner wing/bulk head area (2.1.2 (e) (i)) | 1 |
Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded inner wing/bulkhead area (1.1.21 (e) (i)) | 1 |
Offside Front front brake binding |3.7.B.1| | 1 |
Offside Headlamp insecure (4.1.1 (c)) | 1 |
Offside Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |
Offside Front Steering component mounting prescribed area is excessively corroded lower steering box (2.1.2 (e) (i)) | 1 |
Nearside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt rear most (2.1.3 (g) (ii)) | 1 |
Rear Floor excessively deteriorated floor strengthening brace/s (6.2.4 (a) (i)) | 1 |
Rear Vehicle structure inadequately repaired such that structural rigidity is significantly reduced cross member/ tow bar mounting (6.1.1 (d) (i)) | 1 |
Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis near shock absorber mount (5.3.6 (a) (i)) | 1 |
Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis near shock absorber mount (5.3.6 (a) (i)) | 1 |
Nearside Front Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength near spring shackle (5.3.6 (a) (i)) | 1 |
Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength near spring shackle (5.3.6 (a) (i)) | 1 |
Nearside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis cross member near shackle mounting (5.3.6 (a) (i)) | 1 |
Offside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis cross member near shackle mounting (5.3.6 (a) (i)) | 1 |
Central Rear Lower Suspension component mounting prescribed area is inadequately repaired replacement steel plate not welded along lower edge.
Both rear shackle mounts prescribed area (5.3.6 (a) (i)) | 1 |
Offside Front Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced chassis near bulkhead outrigger (6.1.1 (c) (i)) | 1 |
Nearside Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Chassis area near gearbox support crossmenmber (6.1.1 (c) (i)) | 1 |
Offside Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Chassis area near gearbox support crossmenmber (6.1.1 (c) (i)) | 1 |
Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis near shackle mount (5.3.6 (a) (i)) | 1 |
Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Brakes imbalanced across an axle | 1 |
Brake hose excessively deteriorated | 1 |
Offside Rear Suspension spring mounting prescribed area is fractured |2.4.A.3| | 1 |
Offside Front Suspension spring mounting prescribed area is fractured |2.4.A.3| | 1 |
Nearside Front Suspension spring mounting prescribed area is fractured |2.4.A.3| | 1 |
Offside Vehicle structure is cracked, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Rear Suspension spring mounting prescribed area is inadequately repaired front |2.4.A.3| | 1 |
Offside Parking brake mechanism/associated mounting prescribed area is inadequately repaired |3.1.9| | 1 |
Horn not working |1.6.2a| | 1 |
Offside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Offside Rear Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Offside Front Upper Axle swivel joint has excessive play in a swivel pin |2.5.A.3b| | 1 |
Nearside Front Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Parking brake mechanism/associated mounting prescribed area is excessively corroded |3.1.9| | 1 |
Nearside Rear Upper Shock absorber insecure |2.7.2b| | 1 |