Most common failures | No# failures |
---|
Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 4 |
Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Windscreen wiper does not clear the windscreen effectively | 3 |
Parking brake: efficiency below requirements |3.7.C.1b| | 3 |
Nearside Headlamp not working on main beam |1.7.5a| | 2 |
Offside Headlamp not working on main beam |1.7.5a| | 2 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 2 |
Brake pipe excessively corroded | 2 |
Registration plate lamp issues | 2 |
Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
Offside Seat belt insecurely fixed to the vehicles structure |5.2.1a| | 2 |
Service brake: efficiency below requirements |3.7.C.1a| | 2 |
Rear brake binding | 2 |
Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
Headlamp aim out of alignment | 2 |
Offside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside Headlamp aim not tested |1.8.A.1c| | 1 |
Offside Headlamp aim not tested |1.8.A.1c| | 1 |
Battery insecure |1.9.1| | 1 |
Exhaust emissions hydrocarbon content excessive |7.3.B.1b| | 1 |
Service brake is causing the steering wheel to severely pull one way |3.7.C.2| | 1 |
Rear parking brake recording little or no effort | 1 |
Parking brake lever has no reserve travel |3.1.6b| | 1 |
Offside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Headlamp excessively damaged so that the light output is severely reduced |1.7.5a| | 1 |
Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Steering system has excessive free play detected at the steering wheel |steering box fitted| |2.2.A.1a| | 1 |
Steering box has relative movement between sector shaft and the drop arm |2.2.B.1b| | 1 |
Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Body has a sharp edge caused by damage |6.1.C.1| | 1 |
Nearside Rear Body has a projection caused by damage |6.1.C.1| | 1 |
Rear Exhaust has a part missing |7.1.1a| | 1 |
Offside Front Seat belt retracting mechanism defective |5.2.5b| | 1 |
Nearside Statutory seat belt missing |5.1.1| | 1 |
Centre Statutory seat belt missing |5.1.1| | 1 |
Exhaust emits clearly visible black smoke during acceleration |7.3.A.2c| | 1 |
Nearside Fuel system component insecure |7.2.1| | 1 |
Offside Driver`s seat cannot be secured in the upright position. |6.2.A.2| | 1 |
Centre Driver`s seat cannot be secured in the upright position. |6.2.A.2| | 1 |
Nearside Seat belt insecurely fixed to the vehicles structure |5.2.1a| | 1 |
Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Shock absorber has an excessively worn bush |2.7.4| | 1 |
Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Centre Front Seat belt affected by an insecure seat fixing |5.2.1b| | 1 |
Offside Front Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |