| Most common failures | No# failures |
|---|
| Brake pipe excessively corroded | 4 |
| Headlamp aim out of alignment | 4 |
| Windscreen wiper does not clear the windscreen effectively | 4 |
| Brake fluid warning lamp inoperative |3.6.G.2| | 2 |
| Stop lamp not working |1.2.1b| | 2 |
| Offside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Registration plate lamp issues | 1 |
| Drag link end ball joint has excessive play |2.2.B.1f| | 1 |
| Nearside Drag link end ball joint has excessive play |2.2.B.1f| | 1 |
| Windscreen wiper not operating over a large enough area to give an adequate view |8.2.1c| | 1 |
| Nearside Rear Shock absorber has a serious fluid leak |2.7.3| | 1 |
| Offside Rear fog lamp not working |1.3.2b| | 1 |
| Nearside Passenger`s seat insecure |6.2.A.1| | 1 |
| Steering locking device insecure |2.2.C.1g| | 1 |
| Nearside Front Radius arm locating pin insecure |2.4.G.3a| | 1 |
| Offside Drag link end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Brake pipe inadequately clipped |3.6.B.1| | 1 |
| Nearside Front Lower Suspension arm insecure |2.4.G.1| | 1 |
| Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) | 1 |
| Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength shock mount corroded off of chassis (5.3.6 (a) (i)) | 1 |
| Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting hole in floor osr above shock mount (6.2.2 (d) (i)) | 1 |
| Offside Front Seat belt flexible stalk damaged plastic mechanism cover missing (7.1.2 (b) (i)) | 1 |
| Nearside Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i)) | 1 |
| Offside Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i)) | 1 |
| Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced cross member over top of exhaust (6.1.1 (c) (i)) | 1 |
| Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Nearside Front Upper Suspension component ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Nearside Side repeater not working |1.4.A.2c| | 1 |
| Offside Ball joint has excessive play track rod/tie rod end attatched to steering idler |2.2.B.1f| | 1 |
| Lower Front suspension has excessive play in an outer ball joint |2.5.B.2a| | 1 |
| Offside Front Anti-roll bar has excessive play in a pin/bush D bush |2.4.G.2| | 1 |
| Additional braking device insecure o/s/f brake pipe flexy |3.6.I.1| | 1 |
| Nearside Front Radius arm rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Offside Front Radius arm rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Nearside Front Lower Shock absorber has an excessively worn bush |2.7.4| | 1 |
| Nearside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
| Offside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
| Parking brake lever has no reserve travel |3.1.6b| | 1 |
| Anti-lock braking system warning lamp indicates an ABS fault | 1 |
| Parking brake: efficiency below requirements |3.7.C.1b| | 1 |